Hydrogels with mechanical elasticity and conductivity are ideal materials in wearable devices. However, traditional hydrogels are fragile upon mechanical loading and lose functions in climate change because the internal water undergoes freeze and dehydration. Herein, we synthesize stable emulsions at high and low temperatures by introducing glycerol into the W/W emulsions. Then the high-stable emulsions are used as templates to produce the freestanding emulsion gels with enhanced mechanical strength and conductivity. The introduction of glycerol endows emulsions and emulsion gels with high and low temperature resistance (-20 to 90 °C). The fabricated strain sensors based on emulsion gels show high sensitivity (gauge factor=6.240), high stretchability (1081 %), fatigue resistance, self-healing and adhesion properties, realizing the repeatable and accurate detection of various human motions. These high-performance and eco-friendly emulsion gels can be promising candidates for next-generation artificial skin and human-machine interface.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/chem.202101472 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Optimization and characterization of physicochemical, morphological, structural, thermal, and rheological properties of microwave-assisted extracted pectin from Dillenia indica fruit.
Int J Biol Macromol
January 2025
Department of Food Engineering and Technology, Tezpur University, Napaam, Sonitpur, Tezpur, Assam, India. Electronic address:
Microwave-assisted extraction of pectin from Dillenia indica (DI) fruit was optimized using Box-Behnken design to maximize yield and quality. Parameters such as solid:solvent (1:10-1:30), microwave power (200-600 W), and extraction time (4-10 min) were varied to determine the optimal conditions. Through experimentation, the optimized extraction parameters were identified as 1:23.
View Article and Find Full Text PDFProcessable and controllable all-aqueous gels based on high internal phase water-in-water emulsions.
Mater Horiz
January 2025
Department of Chemical and Biomolecular Engineering, Seoul National University of Science and Technology (SeoulTech), Seoul 01811, Republic of Korea.
Aqueous two-phase systems (ATPSs) have primarily been developed in the form of emulsions to enhance their utilization in green and biocompatible applications. However, numerous challenges have arisen in forming stable and processable water-in-water (W/W) emulsion systems, as well as in fine-tuning the interconnectivity of their internal structure, which can significantly impact their performance. To effectively address these challenges, we elucidate, for the first time, the root cause of the poor stability of W/W emulsions.
View Article and Find Full Text PDFRegulation of whey protein emulsion gel's structure with pullulan to enhance astaxanthin bioaccessibility.
Carbohydr Polym
March 2025
College of Food Science and Engineering, Jilin Agricultural University, Changchun, China; Jilin Province Innovation Center for Food Biological Manufacture, Jilin Agricultural University, Changchun, China; National Processing Laboratory for Soybean Industry and Technology, Changchun, China; National Engineering Laboratory for Wheat and Corn Deep Processing, Changchun, China. Electronic address:
In this study, the potential of using an emulsion gel based on whey protein concentrate (WPC) and pullulan (PUL) to encapsulate and deliver astaxanthin (AST) was investigated. PUL concentration was observed to affect the microstructure of WPC/PUL/AST emulsion gels, and the performance of emulsion gels was evaluated by encapsulation efficiency, simulated gastrointestinal digestion, storage stability, hardness, and water holding capacity tests. The WPC/PUL/AST emulsion gels had the highest encapsulation efficiency, gastrointestinal digestion retention, and bioaccessibility of (91.
View Article and Find Full Text PDFRheological Properties of Emulsions Stabilized by Cellulose Derivatives with the Addition of Ethyl Alcohol.
Materials (Basel)
December 2024
Division of Chemical Engineering and Equipment, Faculty of Chemical Technology, Poznan University of Technology, ul. Berdychowo 4, 60-965 Poznan, Poland.
The paper presents the results of research on the rheological properties and stability of oil-in-water emulsions containing cellulose derivatives: methylcellulose, hydroxyethylcellulose, and hydroxypropylmethylcellulose. The continuous phase of the emulsion was a 70% ethanol (EtOH) solution by volume. The dispersed phase consisted of mineral, linseed, and canola oils (20% by volume).
View Article and Find Full Text PDFThe Effects of Cooking Methods on Gel Properties, Lipid Quality, and Flavor of Surimi Gels Fortified with Antarctic Krill () Oil as High Internal Phase Emulsions.
Foods
December 2024
State Key Laboratory of Marine Food Processing and Safety Control, National Engineering Research Center for Seafood, Collaborative Innovation Center of Provincial and Ministerial Co-Construction for Seafood Deep Processing, Liaoning Province Collaborative Innovation Center for Marine Food Deep Processing, Dalian Technology Innovation Center for Chinese Pre-made Food, College of Food Science and Technology, Dalian Polytechnic University, Dalian 116034, China.
In this study, silver carp surimi products enriched with Antarctic krill oil high internal phase emulsions (AKO-HIPEs) were cooked using steaming (STE), microwave heating (MIC), and air-frying (AIR), respectively. The gel and flavor properties, lipid quality and stability were investigated. Compared to the MIC and AIR groups, the STE surimi gel added with HIPEs had better texture properties, exhibiting higher water-holding capacity and a more homogeneous structure, while the air-frying treatment resulted in visually brighter surimi products.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!