Evaluation of the sealer/gutta-percha ratio on sets of root section surfaces of some extracted teeth sealed using the cold lateral condensation technique.

Canal filling must be well adapted to the walls of the root canal to prevent bacterial infiltration. Endodontic seals play an essential role in ensuring tightness, without which the canal filling would suffer infiltrations. This study aimed to evaluate the areas occupied by the two components of the canal filling, as well as the sealer/gutta-percha ratio in the root canals of the maxillary central incisors after their filling using the cold lateral condensation technique with gutta-percha. Thirty extracted upper central incisors were rotatably prepared with ProTaper Universal up to F3 and sealed using the cold lateral condensation technique with gutta-percha. After setting the sealer, the roots of the teeth were sectioned perpendicularly to 1 (L1), 3 (L3), 6 (L6), and 8 (L8) mm from the apex. The surface of the sections was analyzed with a Leica EZ4D stereomicroscope and photographed at two magnification orders: 10x and 25x. The areas corresponding to the gutta-percha, sealer, gaps, and root canal were expressed in pixels using the ImageJ software, version 1.50i. The difference in the representation of sealer areas, gutta-percha and voids was statistically significantly different for all four sections analyzed. The best adaptation of the canal obturation was observed in L1 and L3. The gutta-percha area was statistically significantly higher than that of the sealer for the L1, L3, and L6 levels, while the sealer/gutta-percha ratio recorded the lowest value at the L3 level (0, 30) and the highest at its L8 (0.70) level, without registering statistically significant differences regarding the area at the four analyzed levels. The voids were mostly absent or recorded a minimal percentage area (<1%). Cold lateral condensation of gutta-percha has led to a good adaptation of gutta-percha to the root canal wall, with a small amount of sealer, especially to the sections made at 3 mm from the apex. Given the limitations of this study, we noted that the voids were few - observed in the 6 and 8 mm sections - and were negligible in many cases.