A considerable amount of platinum (Pt) is required to ensure an adequate rate for the oxygen reduction reaction (ORR) in fuel cells and metal-air batteries. Thus, the implementation of atomic Pt catalysts holds promise for minimizing the Pt content. In this contribution, atomic Pt sites with nitrogen (N) and phosphorus (P) co-coordination on a carbon matrix (PtNPC) are conceptually predicted and experimentally developed to alter the d-band center of Pt, thereby promoting the intrinsic ORR activity. PtNPC with a record-low Pt content (≈0.026 wt %) consequently shows a benchmark-comparable activity for ORR with an onset of 1.0 V and half-wave potential of 0.85 V . It also features a high stability in 15 000-cycle tests and a superior turnover frequency of 6.80 s at 0.9 V . Damjanovic kinetics analysis reveals a tuned ORR kinetics of PtNPC from a mixed 2/4-electron to a predominately 4-electron route. It is discovered that coordinated P species significantly shifts d-band center of Pt atoms, accounting for the exceptional performance of PtNPC.

Download full-text PDF

Source
http://dx.doi.org/10.1002/anie.202107790DOI Listing

Publication Analysis

Top Keywords

d-band center
12
intrinsic orr
8
orr activity
8
atomic sites
8
activity enhancement
4
enhancement atomic
4
sites engineering
4
engineering d-band
4
center local
4
local coordination
4

Similar Publications

Magnesium Oxide-Supported Single Atoms with Fine-Modulated Steric Location for Polymerization Transfer Removal of Water Pollutants.

Environ Sci Technol

December 2024

CAS Key Laboratory of Urban Pollutant Conversion, Department of Environmental Science and Engineering, University of Science & Technology of China, Hefei 230026, China.

Organic pollutants removal via a polymerization transfer (PT) pathway based on the use of single-atom catalysts (SACs) promises efficient water purification with minimal energy/chemical inputs. However, the precise engineering of such catalytic systems toward PT decontamination is still challenging, and the conventional SACs are plagued by low structural stability of carbon material support. Here, we adopted magnesium oxide (MgO) as a structurally stable alternative for loading single copper (Cu) atoms to drive peroxymonosulfate-based Fenton-like reactions.

View Article and Find Full Text PDF

Clarifying the Active Structure and Reaction Mechanism of Atomically Dispersed Metal and Nonmetal Sites with Enhanced Activity for Oxygen Reduction Reaction.

Adv Mater

December 2024

School of Materials Science and Engineering, Tianjin Key Laboratory of Composite and Functional Materials, Key Laboratory of Advanced Ceramics and Machining Technology of Ministry of Education, Tianjin University, Tianjin, 300350, P. R. China.

Atomically dispersed transition metal (ADTM) catalysts are widely implemented in energy conversion reactions, while the similar properties of TMs make it difficult to continuously improve the activity of ADTMs via tuning the composition of metals. Introducing nonmetal sites into ADTMs may help to effectively modulate the electronic structure of metals and significantly improve the activity. However, it is difficult to achieve the co-existence of ADTMs with nonmetal atoms and clarify their synergistic effect on the catalytic mechanism.

View Article and Find Full Text PDF

Green ammonia synthesis using fluctuating renewable energy supply in decentralized process is a goal that has been long sought after. Ammonia synthesis with non-thermal plasma under mild conditions is a promising technology, but it faces the critical challenge of low energy efficiency. Herein, we develop an easily-scalable AuCu3/Cu catalyst, which consists of a decimeter-scale metallic Cu antenna and nano-scale AuCu3 catalytic sites on metallic Cu surface, significantly enhancing the energy efficiency and ammonia yield in a radio-frequency (RF) plasma system.

View Article and Find Full Text PDF

Developing ethanol oxidation electrocatalysts with high catalytic activity, durability, and resistance to CO poisoning remains a major challenge. High-entropy alloys (HEAs) with unique physical and chemical properties have garnered substantial attention. Herein, a class of HEA nanodendrites are designed by a simple wet-chemical method.

View Article and Find Full Text PDF

The electrocatalytic mechanisms of electrocatalysts were constrained by the disparities between the genuine catalytic interface and construction interface. This work demonstrated the relationship between the CuPt nano-alloy atomic ratios and their catalytic performance. Firstly, we developed a facile synthesis of surfactant-free CuPt nano-alloys with tunable Cu atomic ratios (ranging from 35 to 72 at% ) under ambient conditions.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!