Application of thermal desorption for measuring PAHs on PM.

Environ Sci Pollut Res Int

Graduate Institute of Environmental Engineering, National Central University, No. 300, Zhongda Road, Zhongli District, Taoyuan City, 32001, Taiwan.

Published: December 2021

PM and polycyclic aromatic hydrocarbons (PAHs) emitted from various sources may cause respiratory disease and lung cancer. Additionally, PAHs deposited on PM would aggravate the hazard to human health once inhaled. Therefore, it is essential to investigate the PAHs adsorbed on PM in ambient air. However, analysis of PAHs on PM is limited so far due to high detection limit of the analytical method and complex pretreatment procedures of the sample. In this study, thermal desorption (TD) is combined with GC-HRMS for direct analysis of PAHs on PM collected by the filter without pretreatment. The results indicate that distribution of PAHs on the filter is uniform and each filter section is representative for direct analysis of PAHs on PM. The optimal thermal desorption temperature and purge time of analysis are found at 320°C and 60 s, respectively. Furthermore, the PAHs on PM of ambient air in Taiwan including traffic area, industrial area, suburban area, and background site are investigated. The results indicate that the concentrations of PAHs on PM in ambient air of Northern, Central, and Eastern Taiwan are in the range of 0.13-6.63 ng/m, with an average concentration of 2.23 ng/m. The PAH concentration measured in winter is significantly higher than that in summer, and the concentration of PAHs on PM ranges from 0.071 to 0.280 ng/μg while the average concentration is 0.133 ng/μg. The technology optimized in this study can be applied for rapid and accurate measurement of PAHs present on fine particles.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s11356-021-15200-xDOI Listing

Publication Analysis

Top Keywords

thermal desorption
12
pahs
12
ambient air
12
analysis pahs
12
direct analysis
8
pahs ambient
8
average concentration
8
application thermal
4
desorption measuring
4
measuring pahs
4

Similar Publications

We discuss the challenges associated with achieving high energy efficiency in electrochemical ammonia synthesis at near-ambient conditions. The current Li-mediated process has a theoretical maximum energy efficiency of ∼28%, since Li deposition gives rise to a very large effective overpotential. As a starting point toward finding electrocatalysts with lower effective overpotentials, we show that one reason why Li and alkaline earth metals work as N reduction electrocatalysts at ambient conditions is that the thermal elemental processes, N dissociation and NH desorption, are both facile at room temperature for these metals.

View Article and Find Full Text PDF

Atomically precise clusters such as [Pt(CO)(PPh)] ( = 1,2) (PPh is triphenylphosphine) are known as precursors for making oxidation catalysts. However, the changes occurring to the cluster upon thermal activation during the formation of the active catalyst are poorly understood. We have used a combination of hybrid mass spectrometry and surface science to map the thermal decomposition of [Pt(CO)(PPh)](NO).

View Article and Find Full Text PDF

Methylene blue and malachite green dyes adsorption onto /bentonite/tripolyphosphate.

Heliyon

January 2025

Department of Nutrition and Dietetics, Faculty of Health Science, Mardin Artuklu University, Mardin, Turkey.

In the current research mushroom/bentonite clay (RDBNC) as a low-cost bionanosorbent was investigated for adsorption of methylene blue (MB) and malachite green (MG) dye from contaminated water. The bionanosorbent was characterized by Fourier transform infrared (FTIR), X-ray diffraction (XRD), Scanning electron microscopy (FESEM), Thermal Gravimetric Analysis (TGA), and Zeta-potential techniques. Adsorption experiments of RDBNC for MB, MG dyes following Freundlich isotherm and pseudo second order kinetic models.

View Article and Find Full Text PDF

Thermal Desorption Hyphenated to Comprehensive Two-Dimensional Gas Chromatography-Time-of-Flight Mass Spectrometry for Trace Analysis in Raw Renewable Gases-Application to Hydrothermal Gasification.

J Sep Sci

January 2025

Department of Analytical, Bioanalytical Sciences and Miniaturization (LSABM) Chemistry, Biology and Innovation (CBI), UMR CNRS-ESPCI Paris, ESPCI Paris, PSL University, CNRS, Paris, France.

In the context of the energy transition, European countries pursue the common goal of increasing the share of renewable gases (from anaerobic digestion, pyrogasification, and hydrothermal gasification for instance) in the gas mix. Although produced gases are mainly composed of methane after upgrading, impurities of various natures and quantities may also be present in the produced raw gases and still after upgrading, including volatile organic compounds (VOCs) at trace levels that may have an impact on different stages of the gas chain even at low concentrations. These new renewable and/or low-carbon gases imply the need to develop new analytical tools to deeply characterize them, and thus fully manage their integration into the gas value chain.

View Article and Find Full Text PDF

Antibiotics are emerging environmental contaminants posing critical health risks due to their tendency to concentrate in living things and eventually infiltrate the human body. Sulfamethoxazole (SMZ) is among the commonly detected antibiotics in wastewater requiring effective removal approach. A sustainable, thermally stable and easily separable magnetic sporopollenin-cellulose triacetate (Msp-CTA) was developed via a simple step synthesis for eliminating SMZ from aqueous solution.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!