Patch antenna sensor for wireless ice and frost detection.

Sci Rep

Okanagan Microelectronics and Gigahertz Applications Laboratory, School of Engineering, University of British Columbia, Kelowna, BC, V1V 1V7, Canada.

Published: July 2021

A patch antenna sensor with T-shaped slots operating at 2.378 GHz was developed and investigated for wireless ice and frost detection applications. Detection was performed by monitoring the resonant amplitude and resonant frequency of the transmission coefficient between the antenna sensor and a wide band receiver. This sensor was capable of distinguishing between frost, ice, and water with total shifts in resonant frequency of 32 MHz and 36 MHz in the presence of frost and ice, respectively, when compared to the bare sensor. Additionally, the antenna was sensitive to both ice thickness and the surface area covered in ice displaying resonant frequency shifts of 2 MHz and 8 MHz respectively between 80 and 160 μL of ice. By fitting an exponential function to the recorded data, the freezing rate was also extracted. The analysis within this work distinguishes the antenna sensor as a highly accurate and robust method for wireless ice accretion detection and monitoring. This technology has applications in a variety of industries including the energy sector for detection of ice on wind turbines and power lines.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8249444PMC
http://dx.doi.org/10.1038/s41598-021-93082-2DOI Listing

Publication Analysis

Top Keywords

antenna sensor
16
wireless ice
12
resonant frequency
12
ice
9
patch antenna
8
ice frost
8
frost detection
8
frost ice
8
sensor
6
detection
5

Similar Publications

Background: Management of respiratory motion during radiation therapy is essential for accurate dose delivery and minimizing the risk to organs. In diagnostic imaging, respiratory monitoring is required for confirmation of breath-hold and four-dimensional computed tomography (CT) reconstruction. Although respiratory monitoring systems are widely used in radiation therapy, they are not often used for diagnostic imaging, where they could improve image quality.

View Article and Find Full Text PDF

The Laser Interferometer Space Antenna (LISA) mission is designed to detect space gravitational wave sources in the millihertz band. A critical factor in the success of this mission is the residual acceleration noise metric of the internal test mass (TM) within the ultra-precise inertial sensors. Existing studies indicate that the coupling effects of residual gas and temperature gradient fluctuations significantly influence this metric, primarily manifesting as the radiometer effect and the outgassing effect.

View Article and Find Full Text PDF

Feasibility Study on Additive Manufacturing of Feed Horn Operating in D-Band.

Sensors (Basel)

January 2025

Department of Management and Production Engineering (DIGEP), Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy.

This paper presents the outcomes of a feasibility study on the manufacturing of D-band horn antennas through the Low Power Bed Fusion process. Different prototypes have been realized and tested, showing nice results in terms of the co-polarization component. On the other hand, a spurious cross-polarization component is present in the radiation pattern even in the principal planes, limiting the device to single-polarization applications.

View Article and Find Full Text PDF

L-Shaped Coplanar Strip Dipole Antenna Sensor for Adulteration Detection.

Sensors (Basel)

January 2025

Department of Civil Environmental and Mechanical Engineering, University of Trento, 38123 Trento, Italy.

The present study proposes an L-shaped coplanar strip dipole antenna for sensing the presence of adulterants in liquid food samples. The proposed antenna dimensions are optimized using ANSYS HFSS, and a prototype is fabricated and validated. The sensing region is optimized based on the current distribution and measured reflection coefficients.

View Article and Find Full Text PDF

An eight-element MIMO antenna with a neutralization line was utilized for future 5G mm-wave applications. The MIMO configuration was designed for two ports, four ports and eight ports to validate the desired impedance and radiation characteristics. The measured results in terms of MIMO and scattering parameters correlate well with the simulated one.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!