The reclaimed asphalt pavement (RAP) has become a moderately common practice in most countries; Hence, rejuvenating materials with RAP have earned publicity in the asphalt manufacturers, mainly due to the increasing raw material costs. In this study, the crumb rubber (CR) and waste frying oil (WFO) utilized as waste materials to restore the properties and enhance the rutting resistance of the RAP. Several physical, rheological, chemical properties of bituminous binders were tested. The result showed that the RAP bituminous binders incorporating WFO and CR decreased softening points and the increased penetration value; these translate to an increase in penetration index. Moreover, the viscosity of the WFO/CR combination reclaimed asphalt pavement binder showed better workability and stiffness, as well as a low storage stability temperature (less than 2.2 °C) with an acceptable loss upon heating. Without chemical reaction was observed between the waste-frying oil with the rubberized binder and the reclaimed asphalt pavement binder. Additionally, the WFO/CR rheological properties combined with the reclaimed asphalt pavement binder were comparable to the control sample. The incorporation of CR with WFO as a hybrid rejuvenator enhanced the rutting resistance. Therefore, the presence of WFO/CR has a considerable influence on the RAP binder properties while preserving a better environment and reducing pollution by reusing waste materials.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8269486 | PMC |
| http://dx.doi.org/10.3390/ma14133482 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Recycled used cooking oil (UCO) as a rejuvenator in high content reclaimed asphalt pavement (RAP) mixes: A life cycle assessment (LCA).
Sci Total Environ
January 2025
Civil and Infrastructure Engineering, RMIT University, GPO Box 2476, Melbourne, VIC 3001, Australia. Electronic address:
This study investigates the primary data collected at a used cooking oil (UCO) recycling facility to quantify its environmental impact when used as a rejuvenator in high content reclaimed asphalt pavement (RAP) mixes. Annual energy consumption data sets on transportation, storage, filtration, machinery, and purification are assessed using the life cycle assessment (LCA) methodology with the LCA software Simapro 9.4 to evaluate the influential parameters and processes in reducing emissions.
View Article and Find Full Text PDFStudy on Refined Crushing Technology of RAP and Mechanical Properties of RAP-Doped Cement-Stabilised Macadam Base.
Materials (Basel)
January 2025
Gansu Industry Technology Center of Transportation Construction Materials Research and Application, Lanzhou Jiaotong University, Lanzhou 730070, China.
In order to study the effect of the crushing process on the fine separation of reclaimed asphalt pavement (RAP) and the mechanical properties of cement-stabilised aggregate mixed with RAP, four crushing processes, namely small mesh hammer crushing, hammer crushing, jaw crushing, and double roller crushing, were used to separate the aggregate from asphalt in RAP materials. The effect of crushing on the grading characteristics and agglomeration condition of RAP material was investigated. RAP cement-stabilised aggregates were prepared and analysed for their mechanical properties and micro-morphology using RAP materials obtained from fine separation.
View Article and Find Full Text PDFRelease of PAHs from reclaimed asphalt mixtures into the water environment after passivation by cold in-place recycling technology.
Environ Sci Pollut Res Int
January 2025
Transport Research Centre, Líšeňská 33a, 636 00, Brno, Czech Republic.
The paper deals with an analysis of the amount of 16 polycyclic aromatic hydrocarbons (PAHs (Polycyclic aromatic hydrocarbons-16 defined by US EPA.)) released from reclaimed asphalt mixtures used in base layers of road surfaces and in binder layers in road construction using cold in-place recycling. For the ten samples tested, the sum of 16 PAHs was determined directly for the crushed asphalt mixture and for its 24-h leachate.
View Article and Find Full Text PDFEnhancing road performance and sustainability: A study on recycled porous warm mix asphalt.
Sci Total Environ
January 2025
Department of Civil, Chemical, Environmental and Materials Engineering, University of Bologna, Via U. Terracini 28, 40131 Bologna, BO, Italy.
The growing demand for sustainable infrastructure has increased interest in eco-friendly design solutions such as porous asphalt (PA) pavements, which manage stormwater runoff and mitigate urban heat islands, and warm mix asphalt (WMA), which reduces energy consumption and emissions during production. This study evaluates the mechanical and environmental performance of four warm mix porous asphalt (WPA) mixtures incorporating recycled materials and by-products: reclaimed asphalt pavement (RAP), aramid pulp fibres, and electric arc furnace (EAF) steel slag. A Life Cycle Assessment (LCA) with a cradle-to-cradle approach was conducted to comprehensively assess environmental impacts.
View Article and Find Full Text PDFThe Effect of Recycled Geogrid Fibres on Asphalt Concrete Performance: A Case Study from Poland.
Materials (Basel)
December 2024
Department of Civil Engineering and Architecture, Kielce University of Technology, Al. Tysiąclecia Państwa Polskiego 7, 25-314 Kielce, Poland.
This study articulates findings from research pertaining to the utilisation of recycled geogrid in asphalt concrete. The issue of contamination of reclaimed waste with geosynthetic materials persists as a significant concern that warrants attention. In Poland, the allowable quantity of geogrid contaminants within the mineral-asphalt composition is 0.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!