Photonic system component counts are increasing rapidly, particularly in CMOS-compatible silicon photonics processes. Large numbers of cascaded active photonic devices are difficult to implement when accounting for constraints on area, power dissipation, and response time. Plasma dispersion and the thermo-optic effect, both available in CMOS-compatible silicon processes, address a subset of these criteria. With the addition of a few back-end-of-line etch processing steps, silicon photonics platforms can support nano-opto-electro-mechanical (NOEM) phase shifters. Realizing NOEM phase shifters that operate at CMOS-compatible voltages (≤ 1.2 V) and with low insertion loss remains a challenge. Here, we introduce a novel NOEM phase shifter fabricated alongside 90 nanometer transistors that imparts 5.63 radians phase shift at 1.08 volts bias over an actuation length of 25μm with an insertion loss of less than 0.04 dB and 3 dB bandwidth of 0.26 MHz.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.423949DOI Listing

Publication Analysis

Top Keywords

noem phase
16
phase shifter
8
cmos-compatible silicon
8
silicon photonics
8
phase shifters
8
insertion loss
8
phase
5
dual slot-mode
4
noem
4
slot-mode noem
4

Similar Publications

Photonic system component counts are increasing rapidly, particularly in CMOS-compatible silicon photonics processes. Large numbers of cascaded active photonic devices are difficult to implement when accounting for constraints on area, power dissipation, and response time. Plasma dispersion and the thermo-optic effect, both available in CMOS-compatible silicon processes, address a subset of these criteria.

View Article and Find Full Text PDF

Flow microcapillary plasma mass spectrometry-based investigation of new Al-Cr-Fe complex metallic alloy passivation.

Talanta

March 2014

Laboratory for Joining Technologies and Corrosion, EMPA - Swiss Federal Laboratories for Materials Science and Technology, 8600 Dübendorf, Switzerland. Electronic address:

Al-Cr-Fe complex metallic alloys are new intermetallic phases with low surface energy, low friction, and high corrosion resistance down to very low pH values (0-2). Flow microcapillary plasma mass spectrometry under potentiostatic control was used to characterize the dynamic aspect of passivation of an Al-Cr-Fe gamma phase in acidic electrolytes, allowing a better insight on the parameters inducing chemical stability at the oxyhydroxide-solution interface. In sulfuric acid pH 0, low element dissolution rates (in the µg cm(-2) range after 60 min) evidenced the passive state of the Al-Cr-Fe gamma phase with a preferential over-stoichiometric dissolution of Al and Fe cations.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!