Successive Storage of Cations and Anions by Ligands of π-d-Conjugated Coordination Polymers Enabling Robust Sodium-Ion Batteries.

Angew Chem Int Ed Engl

Tianjin Key Laboratory of Molecular Optoelectronic Sciences, Department of Chemistry, School of Sciences, Tianjin University, Tianjin, 300072, China.

Published: August 2021

The oxidation of π-d-conjugated coordination polymers (CCPs) accompanied with anion insertion has the merits of increasing the capacity and elevating the discharge voltages. However, previous reports on this mechanism either required more investigations or showed low capacity and poor cyclablity. Herein, triphenylene-catecholate-based two-dimensional CCPs are constructed by employing inactive transition-metal ions (Zn ) as nodes, forming Zn-HHTP. Substantial characterizations and theoretical calculations indicate the successive storage of cations and anions by redox reactions of only ligands, leading to a high reversible capacity of ≈150 mAh g at 100 mA g and a remarkable capacity retention of 90 % after 1000 cycles. On the contrary, as a control experiment, the analogous CCPs (Cu-HHTP) with Cu nodes, where both ligands and metal ions undergo redox reactions, accompanied by the storage of only Na cations, show a much poorer cyclability. These results highlight the importance of redox reactions of only ligands for long-term cycle life and the insight into the storage mechanisms deepens our understanding on CCPs for the further design of CCPs with high performance.

Download full-text PDF

Source
http://dx.doi.org/10.1002/anie.202106055DOI Listing

Publication Analysis

Top Keywords

storage cations
12
redox reactions
12
successive storage
8
cations anions
8
π-d-conjugated coordination
8
coordination polymers
8
reactions ligands
8
ccps
5
ligands
4
anions ligands
4

Similar Publications

Continuous Electrochemical Carbon Capture via Redox-Mediated pH Swing─Experimental Performance and Process Modeling.

J Phys Chem Lett

January 2025

Department of Process Engineering and Technology of Polymer and Carbon Materials, Wroclaw University of Science and Technology, Wyb. St. Wyspiańskiego 27, 50-370 Wrocław, Poland.

We investigate a continuous electrochemical pH-swing method to capture CO from a gas phase. The electrochemical cell consists of a single cation-exchange membrane (CEM) and a recirculation of a mixture of salt and phenazine-based redox-active molecules. In the absorption compartment, this solution is saturated by CO from a mixed gas phase at high pH.

View Article and Find Full Text PDF

NH-Modulated Cathodic Interfacial Spatial Charge Redistribution for High-Performance Dual-Ion Capacitors.

Nanomicro Lett

January 2025

Shanghai Key Lab of Chemical Assessment and Sustainability, School of Chemical Science and Engineering, Tongji University, Shanghai, 200092, People's Republic of China.

Compared with Zn, the current mainly reported charge carrier for zinc hybrid capacitors, small-hydrated-sized and light-weight NH is expected as a better one to mediate cathodic interfacial electrochemical behaviors, yet has not been unraveled. Here we propose an NH-modulated cationic solvation strategy to optimize cathodic spatial charge distribution and achieve dynamic Zn/NH co-storage for boosting Zinc hybrid capacitors. Owing to the hierarchical cationic solvated structure in hybrid Zn(CFSO)-NHCFSO electrolyte, high-reactive Zn and small-hydrate-sized NH(HO) induce cathodic interfacial Helmholtz plane reconfiguration, thus effectively enhancing the spatial charge density to activate 20% capacity enhancement.

View Article and Find Full Text PDF

Bimetallic Sulfides CrVS with Loosely Packed Structure: Exploring the Boundary of Conversion and Intercalation Sodium-Ion Storage Mechanism.

Nano Lett

January 2025

Shanghai, China State Key Laboratory of High Performance Ceramics and Superfine Microstructure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, China.

Metal sulfide electrodes for sodium-ion batteries face trade-offs among high capacity, fast kinetics, and stability. The challenge lies in breaking and restoring metal-sulfur bonds and allowing rapid ionic transport. Here we explore the boundary of conversion- and intercalation-type metal sulfides to develop ideal sodium-ion storage materials.

View Article and Find Full Text PDF

Sodium-based rechargeable batteries are some of the most promising candidates for electric energy storage with abundant sodium reserves, particularly, sodium-based dual-ion batteries (SDIBs) perform advantages in high work voltage (≈5.0 V), high-power density, and potentially low cost. However, irreversible electrolyte decomposition and co-intercalation of solvent molecules at the electrode interface under a high charge state are blocking their development.

View Article and Find Full Text PDF

ConspectusLithium-ion batteries (LIBs) based on graphite anodes are a widely used state-of-the-art battery technology, but their energy density is approaching theoretical limits, prompting interest in lithium-metal batteries (LMBs) that can achieve higher energy density. In addition, the limited availability of lithium reserves raises supply concerns; therefore, research on postlithium metal batteries is underway. A major issue with these metal anodes, including lithium, is dendritic formation and insufficient reversibility, which leads to safety risks due to short circuits and the use of flammable electrolytes.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!