In this work, a green and simpler method for photometric determination of sulfite based on a flow injection-gas diffusion (FI-GD) system using a natural reagent extracted from roselle ( L.) was proposed. Despite the fact that the employed reaction is not selective to sulfite, its sensitivity is high, and the selectivity can be improved by coupling a GD unit to the FI system. The method involves monitoring a decrease in absorbance of the reagent solution that is used as an acceptor solution. When a standard solution or sample solution was injected into an acidic donor stream, the liberated sulfur dioxide diffuses through a gas-permeable membrane of the GD unit into the acceptor solution, causing color fading of the reagent. A linear analytical curve in the range of 5-100 mg L was obtained with a detection limit of 2 mg·L. Relative standard deviations of 0.9%, 0.6%, and 0.6% were obtained for the determination of 30, 70, and 100 mg·L SO ( = 11). The developed method was applied to wine samples, giving results that agreed with those obtained with the Ripper titrimetric method. The proposed method offers advantages of simplicity, cost-effectiveness, and being environmentally friendly such as reduced chemical consumption and less waste generation.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8154276PMC
http://dx.doi.org/10.1155/2021/6665848DOI Listing

Publication Analysis

Top Keywords

environmentally friendly
8
flow injection-gas
8
injection-gas diffusion
8
natural reagent
8
photometric determination
8
determination sulfite
8
acceptor solution
8
method
5
solution
5
friendly flow
4

Similar Publications

This study focused on fabricating a cellulose aerogel for oil spill clean-up, using common reed () as the cellulose source. The process involved isolating cellulose from reed via traditional Kraft pulping, considering the effects of key factors on the isolated cellulose content. After a two-stage HP bleaching sequence, the highest cellulose content achieved was 27.

View Article and Find Full Text PDF

Masked cryptic kidney injury (MCKI), an early stage of acute kidney injury (AKI), is challenging to detect and diagnose, especially in the modern context where toxic substances, such as surfactants, are increasingly misused. Consequently, there is an urgent need for methods for the visual diagnosis of MCKI. In this study, we synthesized environmentally friendly spirulina-derived carbon dots (SpiCDs) using spirulina as a biobased raw material through a simple hydrothermal process.

View Article and Find Full Text PDF

Micelle-enabled bromination of α-oxo ketene dithioacetals: mild and scalable approach enzymatic catalysis.

Org Biomol Chem

January 2025

Nanotec-CU Center of Excellence on Food and Agriculture, Department of Chemistry, Faculty of Science, Chulalongkorn University, Bangkok 10330, Thailand.

The bromination of α-oxo ketene dithioacetals using KBr/HO, catalyzed by vanadium chloroperoxidase (VCPO), has been successfully demonstrated. A comparative study of enzymatic processes "on water" "in water", using 2 wt% of the surfactant TPGS-750-M revealed that the in-water protocol not only provides higher yields but also accommodates a broader substrate scope. This bromination method in an aqueous micellar medium enabled the preparation of brominated α-oxo ketene dithioacetals in fair to excellent yields (23 examples).

View Article and Find Full Text PDF

As an efficient, sustainable, and environmentally friendly semiconductor material, covalent organic frameworks (COFs) can generate hydrogen peroxide (HO) by photocatalysis, attracting wide attention in recent years. Herein, the effects of hydroxyl, methoxyl, and vinyl groups of imide-linked two-dimensional (2D) COFs on the photocatalytic production of HO were studied theoretically and experimentally. The introduction of vinyl groups greatly promotes the photogenerated charge separation and migration of COFs, providing more oxygen adsorption sites, stronger proton affinity, and lower intermediate binding energy, which effectively facilitates the rapid conversion of oxygen to HO.

View Article and Find Full Text PDF

An increasing amount of water pollution is being caused by an increase in industrial activity. Recently, a wide range of methods, including extraction, chemical coagulation, membrane separation, chemical precipitation, adsorption, and ion exchange, have been used to remove heavy metals from aqueous solutions. The adsorption technique is believed to be the most highly effective method for eliminating heavy metals from wastewater among all of them.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!