Research on the Influence of the AW 5754 Aluminum Alloy State Condition and Sheet Arrangements with AW 6082 Aluminum Alloy on the Forming Process and Strength of the ClinchRivet Joints.

Clinching joints with an additional deformable rivet are modifications of the clinching joints. The clinch riveting (CR) joint is formed indirectly by a deformable rivet. The research included an analysis of CR joints' forming process for aluminum alloy sheets made of AW 6082 in T6 state condition and AW 5754 in three different state conditions: H11, H22 and H24. As a result of forming the joint for various sheet arrangements, the highest value of blocking the upper sheet in the lower sheet () was obtained for the arrangements with two 5754-H24 aluminum alloy sheets. For such a large interlock parameter , the greatest thinning of lower sheet () was obtained, which influenced the maximum tensile shear force and the joint failure mechanism. Based on the load-displacement diagrams obtained from the static shear test of lap joints, the total energy of failure and energy to achieve the maximum load capacity were calculated. The highest energy absorption to achieve the maximum load capacity, in the case of the same sheet materials, was obtained for the 5754-H11 aluminum alloy sheets. On the other hand, among the tested combinations, the highest value of energy absorption (for the joint maximum load capacity) was obtained for the sheet arrangement: top sheet AW 6082-T6 and the bottom AW 5754-H24. The highest value of the total energy up to fracture was obtained when the material of the top sheet was AW 6082-T6, and the bottom AW 5754-H22. For each sheet arrangement, a similar analysis of the joint strength parameters, interlock parameters and forming force were made.