Heat-resistant magnetic polymer composites were prepared by incorporating cerium-doped copper-nickel ferrite particles, having the general formula NiCuFeCeO (x: 0.0, 0.3, 0.6, 1.0), into a polyimide matrix. The effects of particle type and concentration on the thermal, magnetic, and electrical properties of the resulting composites were investigated. The samples were characterized by FTIR, scanning electron microscopy, X-ray diffractometry, thermogravimetric analysis, differential scanning calorimetry, vibrating sample magnetometer, and broadband dielectric spectroscopy. The composites exhibited high thermal stability, having initial decomposition temperatures between 495 and 509 °C. Saturation magnetization (), magnetic remanence (), and coercivity () were found in range of 2.37-10.90 emu g, 0.45-2.84 emu g, and 32-244 Oe, respectively. The study of dielectric properties revealed dielectric constant values of 3.0-4.3 and low dielectric losses of 0.016-0.197 at room temperature and a frequency of 1 Hz.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8158717 | PMC |
| http://dx.doi.org/10.3390/polym13101646 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Use of dielectric-barrier discharge (DBD) cold plasma for control of bread spoilage fungi.
Int J Food Microbiol
December 2024
Department of Food Engineering and Technology, School of Food Engineering, Universidade Estadual de Campinas, São Paulo, Brazil. Electronic address:
Bread is a greatly consumed bakery product worldwide. Unfortunately, it is an optimal substrate for fungal contamination and deterioration (aw > 0.95), commonly caused by the genera Penicillium, Paecilomyces, and Aspergillus, resulting in significant economic losses.
View Article and Find Full Text PDFHydration behavior of asparagine: an approach using time domain reflectometry at low temperatures.
J Biomol Struct Dyn
December 2024
School of Physical Sciences, Swami Ramanand Teerth Marathwada University, Nanded, Maharashtra, India.
The dielectric behavior of Asparagine (CHNO) in water over the frequency range of 10 MHz to 30 GHz in the temperature region of 278.15-303.15 K in a step of 5 K has been carried out using time domain reflectometry (TDR) at various concentrations of asparagine.
View Article and Find Full Text PDFWi-Fi signal for soil moisture sensing.
Environ Monit Assess
December 2024
Division of Soil Science, Institute of Geoecology, TU Braunschweig, Brunswick, Germany.
Measuring soil moisture is essential in various scientific and engineering disciplines. Over recent decades, numerous technologies have been employed for in situ monitoring of soil moisture. Currently, dielectric-based sensors are the most popular measurement technology and provide acceptable accuracy for various measurement purposes.
View Article and Find Full Text PDFPreparation and electromagnetic waves absorption performance of novel peanut shell/CoFeO/(RGO)/PVA nanocomposites.
Sci Rep
December 2024
Department of Physics, Faculty of Science, Razi University, Kermanshah, Iran.
Novel functional materials possessing the capability to attenuate electromagnetic energy are being increasingly incorporated into home decor as concerns over excessive electromagnetic radiation pollution continue to grow. The properties of magnetism and dielectricity in the flexible peanut shell/CoFeO/reduced graphene oxide/polyvinyl alcohol (PS/CF/(RGO)/PVA) nanocomposites can be finely tuned by adjusting the amount of RGO in the mixture. An examination of the composite's absorption capabilities revealed a direct link between higher RGO content and enhanced absorption.
View Article and Find Full Text PDFA comprehensive review of non-invasive optical and microwave biosensors for glucose monitoring.
Biosens Bioelectron
December 2024
Programa de Pós-Graduação em Engenharia Elétrica, Universidade Federal de Minas Gerais, Belo Horizonte, MG, 31270-901, Brazil; Departamento de Engenharia Eletrônica, Universidade Federal de Minas Gerais, Belo Horizonte, MG, 31270-901, Brazil. Electronic address:
Frequent glucose monitoring is essential for effective diabetes management. Currently, glucose monitoring is done using invasive methods such as finger-pricking and subcutaneous sensing. However, these methods can cause discomfort, heighten the risk of infection, and some sensing devices need frequent calibration.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!