Objective: To evaluate the effect of weightlifting (leg press) on intraocular pressure (IOP).

Design: Prospective cohort study.

Subjects: A total of 24 participants met the inclusion criteria and completed the study procedures. Participants had an average age of 22.7±2.7 years and included nine women. The mean baseline IOP was 13.9 mm Hg (SD=2.4) with an average body mass index of 24.5 (SD= 3.1).

Methods: The maximum load for a single lift was found for each participant. Participants then performed three leg press regimens: one repetition using 95% of maximal load (1RM), six repetitions using 75% of maximal load (6RM) and isometric push against a weight much heavier than maximal load (ISO).

Main Outcome Measure: IOP was measured pre-exercise, during and immediately following the exercise using an iCare TA01i rebound tonometer. Blood pressure and HR were being monitored continuously during the lift. Optical coherence tomography images were obtained pre and postexercise session.

Results: The average maximum weight lifted by our participants was 331.9 Kg (SD=97.3). Transient increased IOP was observed across the 1RM, 6RM and ISO exercises with an average increase in 26.4 mm Hg (23.7 mm Hg to 28.7 mm Hg) to reach an average max IOP of 40.7 mm Hg (27.8 mm Hg to 54.2 mm Hg), with an absolute maximum of 70 mm Hg in one participant.

Conclusions: There is a transient and dramatic fluctuation in IOP with resistance training. This coupled with regular exposure to resistance training is potentially a significant risk factor for glaucoma. It should be noted that this study has been carried out in a healthy young population, and, thus, the external validity of these results in glaucoma participants requires further investigation.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8126276PMC
http://dx.doi.org/10.1136/bmjophth-2021-000723DOI Listing

Publication Analysis

Top Keywords

maximal load
12
intraocular pressure
8
leg press
8
resistance training
8
participants
5
average
5
iop
5
pressure fluctuation
4
fluctuation resistance
4
resistance exercise
4

Similar Publications

Effects of Off-Season Heavy-Load Resistance Training on Lower Limb Mechanical Muscle Function and Physical Performance in Elite Female Team Handball Players.

J Funct Morphol Kinesiol

December 2024

Research Unit for Muscle Physiology and Biomechanics (MoB), Department of Sports Science and Clinical Biomechanics, University of Southern Denmark, 5230 Odense, Denmark.

: Team handball involves a high number of rapid and forceful muscle actions. Progressive heavy-load resistance training is known to enhance mechanical muscle function; however, its transfer into functional performance in team handball athletes remains largely unknown. The current study aimed to analyze the effects of eight weeks undulating heavy-load resistance training on lower limb mechanical muscle function and sports-specific performance in elite female team handball players.

View Article and Find Full Text PDF

Male-killing is a microbe-induced reproductive manipulation in invertebrates whereby male hosts are eliminated during development. In the tea tortrix moth Homona magnanima, Osugoroshi viruses 1‒3 (OGVs), belonging to Partitiviridae induce male-killing. The infection patterns of OGVs are diverse; however, how the influence of these patterns of host phenotypes remains largely unknown.

View Article and Find Full Text PDF

Objective: The aim of this study was to examine the acute effects on mechanical, neuromuscular, metabolic, and muscle contractile responses to different set configurations in full-squat (SQ).

Methods: Twenty-two men performed three SQ sessions that consisted of 3 sets of 12 repetitions with 60% 1RM with 4 minutes inter-set rests: a) traditional set (TS): no rest within the set; b) cluster-6 (CS6): a 30 seconds intraset rest after the 6th repetition of each set; and c) cluster-2 (CS2): a 30 seconds intraset rest every 2 repetitions. Mechanical (i.

View Article and Find Full Text PDF

Cornejo-Daza, PJ, Sánchez-Valdepeñas, J, Páez-Maldonado, J, Rodiles-Guerrero, L, Sánchez-Moreno, M, Gómez-Guerrero, G, León-Prados, JA, and Pareja-Blanco, F. Acute responses to different lifting velocities during squat training with and without blood flow restriction. J Strength Cond Res XX(X): 000-000, 2024-The aims of the research were to compare the acute mechanical, metabolic, neuromuscular, and muscle mechanical responses to different lifting velocities (maximal vs.

View Article and Find Full Text PDF

Wear resistance of 3D printed, milled, and prefabricated methacrylate-based resin materials: An in vitro study.

J Prosthet Dent

December 2024

Assistant Professor, Department of Prosthodontics, Faculty of Dentistry, Chiang Mai University, Chiang Mai, Thailand. Electronic address:

Statement Of Problem: Three-dimensional (3D) printing and milling technologies have been increasingly used in prosthodontic practice for fabricating digital prostheses. Nevertheless, evidence relating to the wear resistance of denture teeth fabricated using these methods is lacking.

Purpose: The purpose of this in vitro study was to compare the wear resistance exhibited by denture teeth fabricated using 3D printing and milling technologies with prefabricated denture teeth.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!