We present a CMOS biochip-based photometer for quantitative immunoassay diagnostics. The photometer quantifies the concentration of antigens based on light absorption, which allows for a low-cost implementation without expensive optical components. We propose a light controller to lower the start-up and settling time of the light source to 30 seconds, to facilitate fast measurement starts, and to decrease the overall measurement times. The application-specific integrated circuit (ASIC) contains a 6 x 7-sensor array with 100 μm x 100 μm photodiodes that serve as signal transducers. The ASIC was developed in a normal 0.35- μm CMOS technology, avoiding the need for expensive post-CMOS processes. We present our strategy for the assembly of the ASIC and the immobilization of antibodies. For its first time, we demonstrate the quantification of prostate specific antigen (PSA) with an optoelectronic CMOS biochip using this approach. A PSA immunoassay is performed on the top surface of the CMOS sensor array, enzyme kinetics and PSA concentration are measured within 6 minutes with a limit of detection (LoD) of 0.5 ng/ml, which meets clinical testing requirements. We achieve an overall coefficient of variation (CV) of 7%, which is good compared to other point-of-care (PoC) systems.

Download full-text PDF

Source
http://dx.doi.org/10.1109/TBCAS.2021.3083359DOI Listing

Publication Analysis

Top Keywords

light absorption
8
cmos biochip
8
quantitative immunoassay
8
100 μm
8
cmos
5
light
4
absorption measurement
4
measurement cmos
4
biochip quantitative
4
immunoassay based
4

Similar Publications

Evaluation of tooth-specific optical properties for the development of a non-invasive pulp diagnostic system using Transmitted-light plethysmography: An in vitro study.

Arch Oral Biol

January 2025

Department of Pediatric Dentistry/Dentistry for Persons with Special Needs, Division of Oral Restitution, Graduate School, Institute of Science Tokyo, Japan.

Objectives: Transmitted-light plethysmography (TLP) is an objective and non-invasive pulp diagnosis method that has already been validated for applications for incisors. However, there is a demand for TLP use in the molars, it has not yet been established for this application. This study investigated the optimal light source wavelengths for TLP in premolars, to establish a pulp diagnosis system based on measuring pulpal blood flow.

View Article and Find Full Text PDF

In this study, biopolymer composites based on chitosan (CS) with enhanced optical properties were functionalized using Manganese metal complexes and black tea solution dyes. The results indicate that CS with Mn-complexes can produce polymer hybrids with high absorption, high refractive index and controlled optical band gaps, with a significant reduction from 6.24 eV to 1.

View Article and Find Full Text PDF

The current research aims to determine the impact of orange peel dye (OPD), an eco-friendly addition, on the optical properties of biodegradable polymers. This study investigates the enhancement of optical properties in solid electrolytes based on chitosan (CS) and glycerol, with varying OPD concentrations. UV-Vis-NIR spectroscopy revealed significantly enhanced UV-visible light absorption in the 200-500 nm region and effective UV light blocking.

View Article and Find Full Text PDF

For the effective removal of phenol from the environment, photocatalytic synergistic adsorption is currently one of the key methods. By leveraging the polysaccharide backbone structure of sodium alginate (SA),Zinc hydroxystannate (ZHS) was introduced into the gel structure using a co-precipitation technique. Additionally, gangue waste was repurposed through a polymerization reaction.

View Article and Find Full Text PDF

Awakening n-π* electron transition in structurally distorted g-CN nanosheets via hexamethylenetetramine-involved supercritical CO treatment towards efficient photocatalytic H production.

J Colloid Interface Sci

January 2025

International Research Center for Renewable Energy (IRCRE), State Key Laboratory of Multiphase Flow in Power Engineering (MFPE), Xi'an Jiaotong University (XJTU), Xi'an 710049 PR China.

Graphitic carbon nitride (g-CN) has been regarded as highly potential photocatalyst for solar energy utilization. However, the restricted absorption of visible light for pristine g-CN significantly limits the solar-light-driven chemical reaction efficiency. Herein, structurally distorted g-CN nanosheets with awakened n-π* electron transition were successfully synthesized through hexamethylenetetramine (HMTA)-involved supercritical CO (scCO) treatment and following pyrolysis of melamine precursor.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!