Shear dynamics of confined membranes.

Soft Matter

Institut Lumière Matière, UMR5306 Université Lyon 1-CNRS, Université de Lyon, 69622 Villeurbanne, France.

Published: June 2021

We model the nonlinear response of a lubricated contact composed of a two-dimensional lipid membrane immersed in a simple fluid between two parallel flat and porous walls under shear. The nonlinear dynamics of the membrane gives rise to a rich dynamical behavior depending on the shear velocity. In quiescent conditions (i.e., absence of shear), the membrane freezes into a disordered labyrinthine wrinkle pattern. We determine the wavelength of this pattern as a function of the excess area of the membrane for a fairly general form of the confinement potential using a sine-profile ansatz for the wrinkles. In the presence of shear, we find four different regimes depending on the shear rate. Regime I. For small shear, the labyrinthine pattern is still frozen, but exhibits a small drift which is mainly along the shear direction. In this regime, the tangential forces on the walls due to the presence of the membrane increase linearly with the shear rate. Regime II. When the shear rate is increased above a critical value, the membrane rearranges, and wrinkles start to align along the shear direction. This regime is accompanied by a sharp drop of the tangential forces on the wall. The membrane usually reaches a steady-state configuration drifting with a small constant velocity at long times. However, we also rarely observe oscillatory dynamics in this regime. Regime III. For larger shear rates, the wrinkles align strongly along the shear direction, with a set of dislocation defects which assemble in pairs. The tangential forces are then controlled by the number of dislocations, and by the number of wrinkles between the two dislocations within each dislocation pairs. In this dislocation-dominated regime, the tangential forces in the transverse direction most often exceed those in the shear direction. Regime IV. For even larger shear, the membrane organizes into a perfect array of parallel stripes with no defects. The wavelength of the wrinkles is still identical to the wavelength in the absence of shear. In this final regime, the tangential forces due to the membrane vanish. These behaviors give rise to a non-linear rheological behavior of lubricated contacts containing membranes.

Download full-text PDF

Source
http://dx.doi.org/10.1039/d1sm00322dDOI Listing

Publication Analysis

Top Keywords

tangential forces
20
shear
16
shear direction
16
shear rate
12
direction regime
12
regime tangential
12
membrane
9
regime
9
depending shear
8
absence shear
8

Similar Publications

Background: A surgical robot with force feedback can guarantee precise and gentle manipulation for endometrial repair, ensuring the effectiveness and safety of the manipulation. However, the design of force sensors for surgical robots is challenging due to the limited anatomical space and the requirement for continuous rotation.

Methods: This paper presents a novel force-sensing surgical instrument for endometrial repair, including an inner scraping instrument and an outer force sensing sheath.

View Article and Find Full Text PDF

The distribution of high-viscosity microfilms in designated regions is crucial for the performance and durability of MEMS devices. This paper presents a novel method for controllable film formation in the milli/micron region by blade coating. A microfilm can be formed without viscosity limitation, and the formation process can be monitored only via a one-dimensional force sensor.

View Article and Find Full Text PDF

Ultra-high-performance concrete (UHPC) is a cement-based composite material characterised by exceptional strength, low porosity and high durability, making it highly promising for reinforcement engineering. Based on the theory of tangential modulus, a calculation method has been developed for the axial compression capacity of reinforced concrete (RC) medium and long columns strengthened with UHPC, using the constitutive relation of materials and internal and external force balance conditions. This study analysed the influence of UHPC reinforcement layer thickness, reinforced layer, reinforcement ratio, column slenderness ratio and initial load level of core columns on the bearing capacity of reinforced columns.

View Article and Find Full Text PDF

This report describes the longest case of a retained metallic intraorbital foreign body with no complications and development of delayed sensory exotropia following traumatic sclopetaria in childhood. A 9-year-old girl suffered a BB gun injury to the left eye, leading to chorioretinitis sclopetaria and loss of vision. The visual acuity was 20/800 with a relative afferent pupillary defect and choroidal rupture with subretinal hemorrhage that evolved to sclopetaria over time.

View Article and Find Full Text PDF

In order to solve the problem of drilling deflection, the method of cutting drilling by layers is proposed. The mathematical model of the force of the layered cutting bit was established, and the influencing factors of bit deflection were obtained. The stress equation of the cutting bit is constructed, and the ABAQUS numerical model is established.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!