Aim: To evaluate the real-world performance of the MiniMed 670G system in Europe, in individuals with diabetes.
Materials And Methods: Data uploaded from October 2018 to July 2020 by individuals living in Europe were aggregated and retrospectively analysed. The mean glucose management indicator (GMI), percentage of time spent within (TIR), below (TBR) and above (TAR) glycaemic ranges, system use and insulin consumed in users with 10 or more days of sensor glucose data after initial Auto Mode start were determined. Another analysis based on suboptimally (GMI > 8.0%) and well-controlled (GMI < 7.0%) glycaemia pre-Auto Mode initiation was also performed.
Results: Users (N = 14 899) spent a mean of 81.4% of the time in Auto Mode and achieved a mean GMI of 7.0% ± 0.4%, TIR of 72.0% ± 9.7%, TBR less than 3.9 mmol/L of 2.4% ± 2.1% and TAR more than 10 mmol/L of 25.7% ± 10%, after initiating Auto Mode. When compared with pre-Auto Mode initiation, GMI was reduced by 0.3% ± 0.4% and TIR increased by 9.6% ± 9.9% (P < .0001 for both). Significantly improved glycaemic control was observed irrespective of pre-Auto Mode GMI levels of less than 7.0% or of more than 8.0%. While the total daily dose of insulin increased for both groups, a greater increase was observed in the latter, an increase primarily due to increased basal insulin delivery. By contrast, basal insulin decreased slightly in well-controlled users.
Conclusions: Most MiniMed 670G system users in Europe achieved TIR more than 70% and GMI less than 7% while minimizing hypoglycaemia, in a real-world environment. These international consensus-met outcomes were enabled by automated insulin delivery meeting real-time insulin requirements adapted to each individual user.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1111/dom.14424 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Adaptive promising zone design for sequential parallel comparison design with continuous outcomes.
Clin Trials
January 2025
Department of Biostatistics, University of Florida, Gainesville, FL, USA.
Introduction: The sequential parallel comparison design has emerged as a valuable tool in clinical trials with high placebo response rates. To further enhance its efficiency and effectiveness, adaptive strategies, such as sample size adjustment and allocation ratio modification can be employed.
Methods: We compared the performance of Jennison and Turnbull's method and the Promising Zone approach for sample size adjustment in a two-phase sequential parallel comparison design study.
Low-Complexity Timing Correction Methods for Heart Rate Estimation Using Remote Photoplethysmography.
Sensors (Basel)
January 2025
Department of Biomedical and Robotics Engineering, Incheon National University, Incheon 22012, Republic of Korea.
With the rise of modern healthcare monitoring, heart rate (HR) estimation using remote photoplethysmography (rPPG) has gained attention for its non-contact, continuous tracking capabilities. However, most HR estimation methods rely on stable, fixed sampling intervals, while practical image capture often involves irregular frame rates and missing data, leading to inaccuracies in HR measurements. This study addresses these issues by introducing low-complexity timing correction methods, including linear, cubic, and filter interpolation, to improve HR estimation from rPPG signals under conditions of irregular sampling and data loss.
View Article and Find Full Text PDFMonte Carlo Simulation of the Effect of Melanin Concentration on Light-Tissue Interactions in Reflectance Pulse Oximetry.
Sensors (Basel)
January 2025
Research Centre for Biomedical Engineering, City St George's, University of London, London, EC1V 0HB, UK.
Over the past ten years, there has been an increasing demand for reliable consumer wearables as users are inclined to monitor their health and fitness metrics in real-time, especially since the COVID-19 pandemic. Reflectance pulse oximeters in fitness trackers and smartwatches provide convenient, non-invasive SpO measurements but face challenges in achieving medical-grade accuracy, particularly due to difficulties in capturing physiological signals, which may be affected by skin pigmentation. Hence, this study sets out to investigate the influence of skin pigmentation, particularly in individuals with darker skin, on the accuracy and reliability of SpO measurement in consumer wearables that utilise reflectance pulse oximeters.
View Article and Find Full Text PDFCross-Modal Collaboration and Robust Feature Classifier for Open-Vocabulary 3D Object Detection.
Sensors (Basel)
January 2025
The 54th Research Institute, China Electronics Technology Group Corporation, College of Signal and Information Processing, Shijiazhuang 050081, China.
The multi-sensor fusion, such as LiDAR and camera-based 3D object detection, is a key technology in autonomous driving and robotics. However, traditional 3D detection models are limited to recognizing predefined categories and struggle with unknown or novel objects. Given the complexity of real-world environments, research into open-vocabulary 3D object detection is essential.
View Article and Find Full Text PDFIntegrating Remote Sensing and Soil Features for Enhanced Machine Learning-Based Corn Yield Prediction in the Southern US.
Sensors (Basel)
January 2025
United States Department of Agriculture-Agriculture Research Service, Grassland Soil and Water Research Laboratory, Temple, TX 76502, USA.
Efficient and reliable corn ( L.) yield prediction is important for varietal selection by plant breeders and management decision-making by growers. Unlike prior studies that focus mainly on county-level or controlled laboratory-scale areas, this study targets a production-scale area, better representing real-world agricultural conditions and offering more practical relevance for farmers.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!