One of the most promising electrolytes for all-solid-state lithium batteries is Li La Zr O . Previously, their thermodynamic stability, Li-ion conductivity, and structural features induced by Ga-doping have not been empirically determined or correlated. Here, their interplay was examined for Li Ga La Zr O with target xGa=0, 0.25, 0.50, 0.75, and 1.00 atoms per formula unit (apfu). Formation enthalpies, obtained with calorimetry and found to be exothermic at all compositions, linearly decreased in stability with increased xGa. At dilute xGa substitution, the formation enthalpy curve shifted stepwise endothermically, and the conductivity increased to a maximum, coinciding with 0.529 Ga apfu. This correlated with percolation threshold analysis (0.558 Ga apfu). Further substitution (0.787 Ga apfu) produced a large decrease in the stability and conductivity due to a large increase in point defects and blocked Li-migration pathways. At xGa=1.140 apfu, a small exothermic shift was related to defect cluster organization extending the Li hopping distance and decreased Li-ion conductivity.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8251930 | PMC |
http://dx.doi.org/10.1002/cssc.202100526 | DOI Listing |
Adv Mater
January 2025
School of Materials Science & Engineering, Beijing Institute of Technology, Beijing, 100081, China.
Solid-state lithium (Li) metal batteries (SSLMBs) have garnered considerable attention due to their potential for high energy density and intrinsic safety. However, their widespread development has been hindered by the low ionic conductivity of solid-state electrolytes. In this contribution, a novel Li-rich transport mechanism is proposed to achieve ultrafast Li-ion conduction in composite solid-state electrolytes.
View Article and Find Full Text PDFRSC Adv
January 2025
Department of Physics, BITS Pilani-Pilani Campus RJ-333031 India
The study reports solid-state ceramic supercapacitors (SSCs) assembled using a novel composite electrolyte based on Li ion conducting perovskite-type LLTO (LiLaTiO) and an ionic liquid (EMIM BF). Small amounts of various ionic liquids (ILs) were added to LLTO to enhance the ionic conductivity and improve electrode compatibility. The optimal composition with approximately ∼6 wt% EMIM BF in LLTO exhibited a high ionic conductivity of around ∼10 Ω cm at room temperature, nearly three orders of magnitude higher than that of the pristine LLTO.
View Article and Find Full Text PDFMolecules
January 2025
Key Laboratory of Functional Materials Physics and Chemistry, Ministry of Education, College of Physics, Jilin Normal University, Changchun 130103, China.
The main component of high-capacity silicon-based electrodes is silicon powder, which necessitates intricate processing to minimize volume growth and powder separation while guaranteeing the ideal Si content. This work uses the an situ high-pressure forming approach to create an MXene/-Si/MXene composite electrode, where MXene refers to TiCT, and -Si denotes two-phase mixed nano-Si particles. The sandwich shape promotes silicon's volume growth and stops active particles from spreading.
View Article and Find Full Text PDFMicromachines (Basel)
December 2024
Electronic Convergence Division, Korea Institute of Ceramic Engineering & Technology, 101, Soho-Ro, Jinju 52851, Republic of Korea.
Developing thin-film sheets made of oxide-based solid electrolytes is essential for fabricating surface-mounted ultracompact multilayer oxide solid-state batteries. To this end, solid-electrolyte slurry must be optimized for excellent dispersibility. Although oxide-based solid electrolytes for multilayer structures require sintering, high processing temperatures cause problems such as Li-ion volatilization and reactions with graphite anodes.
View Article and Find Full Text PDFJ Colloid Interface Sci
January 2025
College of Materials Science and Engineering, Nanjing Tech University, Nanjing 211816 China. Electronic address:
Vanadium-based materials exhibit a high theoretical capacity and diverse valence states, rendering them promising candidate anodes for lithium-ion batteries (LIBs). However, the cycling and rate performance are limited by their weak structural stability and electrical conductivity. Herein, a rational amorphization strategy has been developed to construct dual-anion vanadium oxysulfide nanoflowers (VSO NFs) with partial amorphous components and abundant oxygen vacancies as anode material for LIBs.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!