Background: Plasma cell dyscrasias (PCD) are characterized by an abnormal production of intact monoclonal immunoglobulins or parts such as heavy or light chains. In most cases, the monoclonal protein (also termed paraprotein) is produced by a clonal plasma cell population. The production of monoclonal proteins can result in deposits of various types and localization depending on the type, amount, and electrochemical properties of the paraprotein. One histopathologic presentation, albeit rare, are crystalline deposits. They can form in various organs and hence cause a wide spectrum of symptoms.
Case Presentation: A 49-year-old man presented to the emergency department with eyestrain and foreign body sensation after overhead drilling. Examination of the eyes revealed crystalline deposits in the cornea of both eyes. After additional diagnostic testing, deposits were attributed to free light chains. Monoclonal gammopathy of undetermined significance (MGUS) was diagnosed according to serum electrophoresis and immunofixation. Four years later, new onset of proteinuria was detected. A percutaneous biopsy of the kidney showed severe light chain podocytopathy with secondary focal segmental glomerulosclerosis (FSGS) and light chain proximal tubulopathy (LCPT). In these lesions, crystalline deposits identical to the corneal deposits were found in ultrastructural and immunofluorescent analysis. The patient was diagnosed with monoclonal gammopathy of renal significance (MGRS), and a plasma cell directed therapy was initiated.
Conclusions: PCD can present with a wide array of symptoms and are notoriously difficult to diagnose. Extrarenal manifestations such as crystalline deposits in the cornea are one possible manifestation. The case presented herein emphasizes the notion that extrarenal paraprotein deposits warrant a thorough search for the underlying clonal disease.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8025562 | PMC |
http://dx.doi.org/10.1186/s12882-021-02309-x | DOI Listing |
Sci Rep
January 2025
Department of Graphic Arts and Photophysics, Faculty of Chemical Technology, University of Pardubice, Studentská 573, Pardubice, 532 10, Czech Republic.
Radio frequency magnetron co-sputtering method employing GeTe and Sc targets was exploited for the deposition of Sc doped GeTe thin films. Different characterization techniques (scanning electron microscopy with energy-dispersive X-ray analysis, X-ray diffraction, atomic force microscopy, sheet resistance temperature-dependent measurements, variable angle spectroscopic ellipsometry, and laser ablation time-of-flight mass spectrometry) were used to evaluate the properties of as-deposited (amorphous) and annealed (crystalline) Ge-Te-Sc thin films. Prepared amorphous thin films have GeTe, GeTeSc, GeTeSc, GeTeSc and GeTeSc chemical composition.
View Article and Find Full Text PDFJ Chem Phys
January 2025
Graduate School of Engineering, Chiba University, 1-33, Yayoi-cho, Inage-ku, Chiba, Chiba 263-8522, Japan.
Organic multilayer systems, which are stacked layers of different organic materials, are used in various organic electronic devices such as organic light-emitting diodes (OLEDs) and organic field-effect transistors (OFETs). In particular, OFETs are promising as key components in flexible electronic devices. In this study, we investigated how the inclusion of an insulating tetratetracontane (TTC) interlayer in ambipolar indigo-based OFETs can be used to alter the crystallinity and electrical properties of the indigo charge transport layer.
View Article and Find Full Text PDFScience
January 2025
Department of Electrical Engineering, Stanford University, Stanford, CA, USA.
The electrical resistivity of conventional metals such as copper is known to increase in thin films as a result of electron-surface scattering, thus limiting the performance of metals in nanoscale electronics. Here, we find an unusual reduction of resistivity with decreasing film thickness in niobium phosphide (NbP) semimetal deposited at relatively low temperatures of 400°C. In films thinner than 5 nanometers, the room temperature resistivity (~34 microhm centimeters for 1.
View Article and Find Full Text PDFMater Horiz
January 2025
Department of Chemical Engineering, National Tsing Hua University, 101, Section 2, Kuang-Fu Road, Hsin-Chu 300044, Taiwan.
The formation of a high-density nanotwinned structure in copper deposits is presently acknowledged as a paramount goal for enhancing the material characteristics of copper. However, the conventional manufacturing processes often involve the incorporation of organic additives, resulting in consequential impurity effects and aging concerns. In this work, we introduce a high-rate approach to fabricate (220)-orientation nanotwinned copper foils in a concentrated methanesulfonate copper solution with mere amount of chloride ions as additives.
View Article and Find Full Text PDFACS Omega
December 2024
Health Effects Laboratory Division (HELD), National Institute for Occupational Safety and Health (NIOSH) Centers for Disease Control and Prevention (CDC),1090 Tusculum Ave,Cincinnati, Ohio 45226, United States.
Inhalation exposure to respirable crystalline silica (RCS) during the fabrication of engineered stone-based kitchen countertops has been on the rise in recent years and has become a significant occupational health problem in the United States and globally. Little is known about the presence of nanocrystalline silica (NCS), i.e.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!