Even though unmanned aerial vehicles (UAVs) are taking on more expansive roles in military and commercial applications, their adaptability and agility are still inferior to that of their biological counterparts like birds, especially at low and moderate Reynolds numbers. A system of aeroelastic devices used by birds, known as the covert feathers, has been considered as a natural flow-control device for mitigating flow separation, enhancing lift, and delaying stall. This study presents the effects of a covert-inspired flap on two airfoils with different stall characteristics at Reynolds numbers in the order of 10, where small scale UAVs operate. Detailed experiments and simulations are used to investigate how the covert-inspired flap affects lift and drag on an airfoil that exhibits sharp or sudden stall (i.e. the NACA 2414 airfoil) and one that exhibits soft or gradual stall (i.e. an E387(A) airfoil). The effects of the flap chord-wise locations and deflection angles on lift and drag is investigated, through wind tunnel experiments, for two types of flaps namely, a freely-moving flap and a static flap. Results show that the static covert-inspired flap can delay stall by up to 5° and improve post-stall lift by up to 23%. However, the post-stall lift improvement characteristics and sensitivities are highly affected by the airfoil choice. For the soft stall airfoil (i.e. E387(A)), the stall onset delay is insensitive to changing the flap deflection angle, and the flap becomes ineffective when the flap location is changed. In contrast, for the sharp stall airfoil (i.e. NACA 2414), the post-stall lift improvements can be tuned using the flap deflection angle, and the flap remains effective over a wide range of chord-wise locations. Numerical studies reveal that the lift improvements are attributed to a step in the pressure distribution over the airfoil, which allows for lower pressures on the suction side upstream of the flap. The distinctions between the flap-induced lift enhancements on the soft and sharp stall airfoils suggest that the flap can be used as a tunable flow control device for the sharp stall airfoil, while for the soft stall airfoil, it can solely be used as a stall mitigation device that is either on or off.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1088/1748-3190/abf3b3 | DOI Listing |
Bioinspir Biomim
December 2024
Department of Aerospace Engineering, Adana Alparslan Türkeş Science and Technology University, Faculty of Aeronautics and Astronautics, Department of Aerospace Engineering, Adana, 01250, TURKEY.
An experimental study was carried out to investigate the effects of biomimetic vortex generators (biomimetic-VGs) on the aerodynamic performance of the NACA0015 airfoil. Aerodynamic force measurements and titanium dioxide (TiO) based flow visualization technique experiments were performed for test models at Re=1.2×10.
View Article and Find Full Text PDFHeliyon
June 2024
Mechanical Engineering Department, Faculty of Engineering, Fayoum University, 63514, Fayoum, Egypt.
This study provides a detailed analysis of the aerodynamic performance of various airfoil configurations, focusing on lift coefficient, stall characteristics, and maximum lift-to-drag ratio. The investigation includes the NACA23012C profile and configurations with different step geometries, ranging from one-step to five-step designs. Experimental measurements were conducted using a well-equipped aerodynamic laboratory, Institute of Aviation Engineering and Technology (IAET), Giza, Egypt.
View Article and Find Full Text PDFBiomimetics (Basel)
June 2024
Faculty of Aerospace Engineering, POLITEHNICA National University of Science and Technology Bucharest, 060042 Bucharest, Romania.
A numerical method for generating dynamic stall using ANSYS Fluent and a user-defined function (UDF), with the complete script shared for reference, is introduced and tested. The study draws inspiration from bird flight, exploring dynamic stall as a method for achieving enhanced aerodynamic performance. The numerical method was tested on NACA 0012 airfoils with corresponding chord lengths of c1=40 mm, c2=150 mm, and c3=300 mm at Reynolds numbers ranging from Re1=2.
View Article and Find Full Text PDFHeliyon
June 2024
Department of Mechanical Engineering, Bangladesh University of Engineering and Technology, Dhaka, 1000, Bangladesh.
Since the Wright Brothers' first flight in 1903, extensive research has been dedicated to improving the aerodynamic performance of aircraft. This study investigates the effect of two distinct wing geometric modifications on airfoil performance at high angles of attack (AOAs). These two modifications are slot, specifically the NACA 4412 with only a slot, and groove, specifically the NACA 4412 with both a slot and a groove.
View Article and Find Full Text PDFHeliyon
June 2024
Jomo Kenyatta University of Agriculture and Technology, Faculty of Engineering, Department of Electrical and Electronics Engineering, Nairobi, Kenya.
Wind is an emerging renewable energy resource, but more useful in cold regions. With the increasing threat of climate change and global warming, the unpredictability of wind energy patterns has been affected. With continual threats from extremes and uncertainties, icing on wind turbines has been noted to grow affecting aerodynamic performance.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!