Room-temperature (RT) sodium-sulfur (Na-S) batteries hold great promise for large-scale energy storage due to the advantages of high energy density, low cost, and resource abundance. The research progress on RT Na-S batteries, however, has been greatly hindered by the sluggish kinetics of the sulfur redox reactions. Herein, an elaborate multifunctional architecture, consisting of N-doped carbon skeletons and tunable MoS sulfiphilic sites, is fabricated via a simple one-pot reaction followed by in situ sulfurization. Beyond the physical confinement and chemical binding of polarized N-doped carbonaceous microflowers, the MoS active sites play a key role in catalyzing polysulfide redox reactions, especially the conversion from long-chain Na S (4 ≤ n ≤ 8) to short-chain Na S and Na S. Significantly, the electrocatalytic activity of MoS can be tunable via adjusting the discharge depth. It is remarkable that the sodiated MoS exhibits much stronger binding energy and electrocatalytic behavior compared to MoS sites, effectively enhancing the formation of the final Na S product. Consequently, the S cathode achieves superior electrochemical performance in RT Na-S batteries, delivering a high capacity of 774.2 mAh g after 800 cycles at 0.2 A g , and an ultrahigh capacity retention with a capacity decay rate of only 0.0055% per cycle over 2800 cycles.

Download full-text PDF

Source
http://dx.doi.org/10.1002/adma.202100229DOI Listing

Publication Analysis

Top Keywords

na-s batteries
16
redox reactions
12
electrocatalytic behavior
8
sodiated mos
8
mos active
8
active sites
8
sulfur redox
8
mos
6
tunable electrocatalytic
4
behavior sodiated
4

Similar Publications

Operando Synchrotron X-Ray Absorption Spectroscopy: A Key Tool for Cathode Material Studies in Next-Generation Batteries.

Adv Sci (Weinh)

January 2025

Institute for Superconducting & Electronic Materials (ISEM), Faculty of Engineering and Information Sciences (EIS), University of Wollongong, Wollongong, NSW, 2500, Australia.

Rechargeable batteries are central to modern energy storage systems, from portable electronics to electric vehicles. The cathode material, a critical component, largely dictates a battery's energy density, capacity, and overall performance. This review focuses on the application of operando X-ray absorption spectroscopy (XAS) to study cathode materials in Li-ion, Na-ion, Li-S, and Na-S batteries.

View Article and Find Full Text PDF

Enhanced Polysulfide conversion in Room-Temperature Sodium-Sulfur batteries via nanoscale TiO modified porous carbon structures.

J Colloid Interface Sci

April 2025

School of Materials and Energy, and LONGi Institute of Future Technology, Lanzhou University, Lanzhou 730000 China. Electronic address:

Room-temperature sodium-sulfur (RT Na-S) batteries, known for their high-energy density, low cost and environmental friendliness, have attracted much attention. However, the development of RT Na-S batteries has encountered a number of challenges, including low conductivity and large volume changes of sulfur during the charge-discharge cycles. In this study, TiO nanoparticles modified porous carbon hosts for sulfur in RT Na-S batteries were prepared by a simple and efficient spray drying method combined with solution immersion.

View Article and Find Full Text PDF

Nickel-rich NCM cathode materials promise lithium-ion batteries with a high energy density. However, an increased Ni fraction in the cathode leads to complex phase transformations with electrode-electrolyte side reactions, which cause rapid capacity fading. Here, we show that an initial formation cycle at 0.

View Article and Find Full Text PDF

Room-temperature sodium-sulfur (RT Na-S) batteries that typically feature multielectron conversion chemistries can allow an ultrahigh specific capacity of 1675 mA h g and a high energy density of 1275 W h kg but unfortunately suffer from a lot of intractable challenges from sulfur cathodes. These issues cover the poor electronic conductivity of pristine sulfur and solid products, the severe shuttle effect of polysulfides, and the sluggish redox kinetics, The shuttling behavior of polysulfides always leads to cathode/anode instability and performance degeneration. Recently, the emerging catalysis strategy has been demonstrated as a reliable pathway to tackle the central issues caused by sulfur electrochemistry and revitalize RT Na-S batteries.

View Article and Find Full Text PDF

Recent progress of density functional theory studies on carbon-supported single-atom catalysts for energy storage and conversion.

Chem Commun (Camb)

January 2025

Institute for Carbon Neutralization Technology, College of Chemistry and Materials Engineering, Wenzhou University, Wenzhou, Zhejiang 325035, China.

Single-atom catalysts (SACs) have become the forefront and hotspot in energy storage and conversion research, inheriting the advantages of both homogeneous and heterogeneous catalysts. In particular, carbon-supported SACs (CS-SACs) are excellent candidates for many energy storage and conversion applications, due to their maximum atomic efficiency, unique electronic and coordination structures, and beneficial synergistic effects between active catalytic sites and carbon substrates. In this review, we briefly review the atomic-level regulation strategies for optimizing CS-SACs for energy storage and conversion, including coordination structure control, nonmetallic elemental doping, axial coordination design, and polymetallic active site construction.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!