In this study, bitumen modified by fumed silica nanoparticles was characterized through dynamic shear rheometer tests, scanning electron microscopy, and Fourier transform infrared spectroscopy. The fumed silica nanoparticles were used in three different ratios, i.e., 0.1, 0.2 and 0.3 wt.-% of bitumen. Specifically, the modified bitumen characteristics were studied after laboratory aging by analyzing the chemical composition and rheological properties. From the determination of oxidation degree and carbonyl index it was found that the resistance of the modified bitumen to ultraviolet aging was improved with the increasing nanoparticle content. In bitumen modified by fumed silica nanoparticles, the nanoparticles were well dispersed. Moreover, the results illustrated that the bitumen properties were improved, and the improvement effect of 0.1 wt.-% fumed silica nanoparticles was more distinct than the higher concentrations.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7916902 | PMC |
| http://dx.doi.org/10.3390/nano11020454 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Stability and Rheological Properties of the Novel Silica-Based Organogel-A Drug Carrier with High Solubilization Potential.
Materials (Basel)
January 2025
Department of Applied Chemistry, Faculty of Chemistry, Adam Mickiewicz University, Uniwersytetu Poznańskiego 8, 61-614 Poznań, Poland.
Dissolution of a poorly soluble active pharmacological substance in a drug carrier usually requires advanced techniques and production equipment. The use of novel carriers such as microemulsions, vesicles, or nanocarriers might entail various limitations concerning production cost, formulation stability, or active substance capacity. In this paper, we present a novel fumed silica-based organogel as a low-cost, simple preparation drug or cosmetic carrier with interesting rheological properties and high solubilization capacity.
View Article and Find Full Text PDFShear thickening inside elastic open-cell foams under dynamic compression.
Soft Matter
January 2025
James Franck Institute and Department of Physics, The University of Chicago, Chicago, Illinois 60637, USA.
We measure the response of open-cell polyurethane foams filled with a dense suspension of fumed silica particles in polyethylene glycol at compression speeds spanning several orders of magnitude. The gradual compressive stress increase of the composite material indicates the existence of shear rate gradients in the interstitial suspension caused by wide distributions in pore sizes in the disordered foam network. The energy dissipated during compression scales with an effective internal shear rate, allowing for the collapse of three data sets for different pore-size foams.
View Article and Find Full Text PDFThe impact of glidants on the rheological properties of active pharmaceutical ingredients: A study of conventional and alternative flow enhancers.
Int J Pharm
January 2025
Laboratory of Pharmaceutical Technology, Department of Pharmaceutics, Ghent University, Ottergemsesteenweg 460, B-9000 Ghent, Belgium.
Nowadays, most of the newly developed active pharmaceutical ingredients (APIs) consist of cohesive particles with a mean particle size of <100μm, a wide particle size distribution (PSD) and a tendency to agglomerate, therefore they are difficult to handle in continuous manufacturing (CM) lines. The current paper focuses on the impact of various glidants on the bulk properties of difficult-to-handle APIs. Three challenging powders were included: two extremely cohesive APIs (acetaminophen micronized (APAPμ) and metoprolol tartrate (MPT)) which previously have shown processing issues during different stages of the continuous direct compression (CDC)-line and a spray dried placebo (SD) powder containing hydroxypropylmethyl cellulose (HPMC), known for its sub-optimal flow with a high specific surface area (SSA) and low density.
View Article and Find Full Text PDFEnhanced lithium-ion battery performance with a novel composite anode: S-doped graphene oxide, polypyrrole, and fumed silica.
Nanotechnology
January 2025
Faculty of Art and Sciences, Department of Chemistry, Yildiz Technical University, 34220 Istanbul, Turkey.
In this work, a novel composite anode material was developed, utilizing S-doped graphene oxide (SGO), polypyrrole (PPy), and fumed silica to enhance the performance of lithium-ion batteries (LIBs). The chronoamperometric approach was used to produce SGO, while the chemical method was employed to synthesize PPy. A composite of SGO, PPy, and fumed silica was prepared as an anode for a half-cell, using two samples: one with a high PPy ratio (S1) and the other with a low PPy ratio (S2) and compared the results with bare sample (S0).
View Article and Find Full Text PDFEffect of Hydrophobic Fumed Silica on Bending Strength of Sodium Silicate-Bonded Sand Cores.
Materials (Basel)
November 2024
Ningbo Institute of Technology (NIT), Beihang University, Ningbo 315000, China.
Inorganic sand cores involving sodium silicate binder and microsilica have environmental advantages during the casting process of aluminum alloy. Nevertheless, the bending strength of sodium silicate-bonded sand (SSBS) needs to be further improved. In this research, the effect of hydrophobic fumed silica on the bending strength of sand cores was studied.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!