The Zn/Fe-modified biochar on nitrobenzene (NB) removal during the electrolysis was investigated in this study. Both the Fe and Zn-modified biochar enhanced the NB adsorption compared with the un-modified biochar due to their greater specific surface area and more abundant surface function groups, respectively. The electrolysis under 2-11 V with the assist of both Fe/Zn-modified biochar achieved effective NB removal (>93%). The removal rate under 2 V using Zn/Fe-modified biochar (∼94%) was higher than that of the un-modified biochar (∼80%), whereas the removal was similar for those under 5, 8 and 11 V. The NB removal under 2 and 5 V was attributed to both adsorption and electrochemical decomposition of NB molecules. Electrolysis under 5 V by Fe-modified biochar had a higher degree of NB mineralisation than that using un-modified and Zn-modified biochar. This was likely that the Fe-modified biochar exhibited higher electrocatalytic properties, facilitating the further NB mineralisation. The ∙OH played significant roles in the degradation of NB by Fe-modified and un-modified biochar but did not significantly participated for the test using Zn-modified biochar. This was possibly because the Zn-modified biochar could adsorb greater amounts of ∙OH into the inner pores of Zn-modified biochar via its greater porosity and specific surface area, which may prevent the contact between ∙OH and NB molecules.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.chemosphere.2021.129966 | DOI Listing |
Environ Technol
August 2024
Center of Excellence on Catalysis and Catalytic Reaction Engineering (CECC), Department of Chemical Engineering, Faculty of Engineering, Chulalongkorn University, Bangkok, Thailand.
In this study, the efficiency of a series of biochar-supported Cu catalysts, biochar-supported Zn catalysts, and biochar-supported Cu-Zn catalysts was determined through bioethanol dehydrogenation to the high-value chemical, acetaldehyde. Each metal, with weight percentages of 10, 20, and 30, and the combination of Cu-Zn, including 10 wt% of Cu and Zn, 15 wt% of Cu - 5 wt% of Zn, and 15 wt% of Cu and Zn, were fully loaded onto biochar using an incipient wetness impregnation technique. Subsequently, all biocatalysts were subjected to bioethanol dehydrogenation reactions in a temperature range of 200-400 °C.
View Article and Find Full Text PDFHeliyon
June 2024
School of Energy, Materials and Chemical Engineering, Hefei University, 99 Jinxiu Avenue, Hefei, 230601, China.
The modified coconut shell biochars (MCSBCs) were fabricated and their adsorptions for Pb(II) were evaluated, in which waste coconut shell was used as the raw material, both ZnCl and KMnO were applied as the inorganic modifiers. FT-IR spectra, TGA, SEM and BET techniques were utilized to characterize their properties. It was spotted that the thermal stability of UCSBC could arrive at 500 °C.
View Article and Find Full Text PDFJ Environ Manage
December 2023
State Key Laboratory of Food Science and Resources, Engineering Research Center for Biomass Conversion, Ministry of Education, Nanchang University, Nanchang, Jiangxi 330047, PR China.
Microplastics (MPs) have already spread across the globe and have been found in drinking water and human tissues. This may pose severe threats to human health and water environment. Therefore, this study accurately evaluated the removal effect of metal-modified biochar on polystyrene microplastics (PS-MPs) (1.
View Article and Find Full Text PDFMolecules
March 2023
Centre for Water Management and Reuse, University of South Australia, Mawson Lakes Campus, Adelaide, SA 5095, Australia.
To remove typical herbicide diuron effectively, a novel sludge-derived modified biochar (SDMBC600) was prepared using sludge-derived biochar (SDBC600) as raw material and Fe-Zn as an activator and modifier in this study. The physico-chemical properties of SDMBC600 and the adsorption behavior of diuron on the SDMBC600 were studied systematically. The adsorption mechanisms as well as practical applications of SDMBC600 were also investigated and examined.
View Article and Find Full Text PDFEnviron Sci Pollut Res Int
April 2023
Department of Chemistry, National Institute of Technology, Silchar, 788010, Assam, India.
Herein, a novel nanocomposite, namely, Zn-modified CeO@biochar (Zn/CeO@BC), is synthesized via facile one-step sol-precipitation to study its photocatalytic activity towards the removal of methylene blue dye. Firstly, Zn/Ce(OH)@biochar was precipitated by adding sodium hydroxide to cerium salt precursor; then, the composite was calcined in a muffle furnace to convert Ce(OH) into CeO. The crystallite structure, topographical and morphological properties, chemical compositions, and specific surface area of the synthesized nanocomposite are characterized by XRD, SEM, TEM, XPS, EDS, and BET analysis.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!