Objective: To demonstrate the efficacy of the SafeZone UVC (Ushio Inc., Japan) 222 nm ultraviolet C (UVC) light to reduce bacterial burden in pressure ulcers (PUs) in human patients. This research is the first human clinical trial using 222 nm UVC in eradicating bacteria in human wounds.

Method: Patients with Stage 2 or 3 (as defined by the revised National Pressure Ulcer Advisory Panel Pressure Injury Staging System) sacral or gluteal pressure ulcers (PUs) were subjected to four sessions of 222 nm UVC light therapy over two weeks. Pre- and post-UVC therapy, wound cultures were taken and quantitative analysis of bacterial colony forming units (CFU) were performed.

Results: A total of 68 UV light sessions across 16 different patients were conducted. Of these sessions, 59 (87.0%) sessions showed a reduction in CFU counts, with 20 (29.4%) showing complete eradication of bacteria. Bacteria identified included meticillin-resistant and . The overall median reduction in CFU of the 68 sessions was 78.9%. No adverse events were reported in any of the UV sessions.

Conclusion: In this study, 222 nm UVC light was safe and effective in reducing bacterial CFU counts in sacral and gluteal PUs across numerous different species of bacteria.

Download full-text PDF

Source
http://dx.doi.org/10.12968/jowc.2021.30.2.96DOI Listing

Publication Analysis

Top Keywords

uvc light
12
222 uvc
12
pressure ulcers
8
ulcers pus
8
sacral gluteal
8
reduction cfu
8
cfu counts
8
0
5
uvc
5
sessions
5

Similar Publications

The effectiveness of ultraviolet-C light-emitting diodes (UVC LEDs) is currently limited by the lack of suitable encapsulation materials, restricting their use in sterilization, communication, and in vivo cancer tumor inhibition. This study evaluates various silicone oils for UVC LED encapsulation. A material aging experiment was conducted on CF1040 (octamethylcyclotetrasiloxane), HF2020 (methyl hydro polysiloxanes), and MF2020-1000 (polydimethylsiloxane) under UVC radiation for 1000 h.

View Article and Find Full Text PDF

Controlling the microorganisms employed in vinification is a critical factor for successful wine production. Novel methods aimed at lowering sulfites used for wine stabilization are sought. UV-C irradiation has been proposed as an alternative for reducing the viable cell count of microorganisms in wine and grape juice.

View Article and Find Full Text PDF

Energy delivered at different wavelengths causes different types of damage to DNA. PC-3, FaDu, 4T1 and B16-F10 cells were irradiated with different wavelengths of ultraviolet light (UVA/UVC) and ionizing radiation (X-ray). Furthermore, different photosensitizers (ortho-iodo-Hoechst33258/psoralen/trioxsalen) were tested for their amplifying effect.

View Article and Find Full Text PDF

First evidence that antibiotic-resistant bacteria are inactivated by chemical species produced through the solar photosensitization of ciprofloxacin in water.

Sci Total Environ

February 2025

Grupo de Investigación en Remediación Ambiental y Biocatálisis (GIRAB), Instituto de Química, Facultad de Ciencias Exactas y Naturales, Universidad de Antioquia UdeA, Calle 70 No. 52-21, Medellín, Colombia. Electronic address:

For the first time, using a chemical pollutant (an antibiotic) as a photosensitizer to improve the elimination of a microbiological contaminant of emerging concern (antibiotic-resistant bacteria) is presented. The effect of ciprofloxacin (CIP) on the inactivation of three light-promoted antibiotic-resistant bacteria (ARB) was evaluated. Ciprofloxacin-resistant Escherichia coli, ciprofloxacin-resistant Staphylococcus aureus, and carbapenem-resistant Klebsiella pneumoniae.

View Article and Find Full Text PDF

Ultraviolet-Shielded Transparent Wood with Improved Interface for Insulating Windows.

ACS Appl Mater Interfaces

January 2025

MOE Engineering Research Center of Forestry Biomass Materials and Bioenergy, Beijing Forestry University, Beijing 100083, China.

Recently, transparent wood (TW) has been considered for many energy-efficient building products, such as windows and decorations. However, the existing TW still faces issues with size and thickness, as well as problems with functional fillers affecting the optical and mechanical properties of TW, which limits its wide application in the window products. In this study, a wood composite material (WCM) with good optical, mechanical, and thermal insulation and UV-shielding properties was prepared by using delignified wood (DW), methyl methacrylate (MMA), and 4-vinylphenylboric acid (VPBA).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!