The objective of this study was to apply the technique of electrosorption in order to assess the capacity of heterogeneous adsorption under an electric field. This was to enhance the adsorption capacity of the nanoparticles, to shorten the adsorption time, and to reduce the cost of the purification of contaminated waters. A final objective of this study was to compare the free adsorption (FA) and the electrosorption (ES) to understand the interface adsorbent/adsorbate at different contact conditions. For these purposes, a potentially efficient, environment-friendly absorbent was synthesized for dechromation purposes. The experimental design method generated optimum conditions as t = 123 min, T = 318°K, and C = 100 mg/L. Freundlich's well-fitted modeling proved that the adsorption of chromate (VI) on nano-AlO occurred on a homogenous surface. In addition, the adsorption coefficient intensity n did not only confirm monolayer adsorption but also indicated a favorable adsorption process. Thermodynamic studies confirmed the reaction spontaneity and the physisorption of the process. The electrosorption process was also tested using 20mA/cm as applied current density. Free-adsorption (FA) and electrosorption (ES) processes were compared. The maximum recorded yield was 99% for (EA) against 87% for (FA). EDS analysis recorded 11.3% of chromate adsorbate with free adsorption. The amount of Cr (VI) on nano-AlO was 42.5 %. Nevertheless, the AlO nanoparticles lost their crystallinity and exploded after the ES process. Mechanisms of both (FA) and (ES) were proposed.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1007/s11356-021-12612-7 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Local control of S atoms on the Co-SACs for effective activation of PMS and degradation imidacloprid: Mechanism insights and toxicity evaluation.
Ecotoxicol Environ Saf
January 2025
School of Eco-Environment, Hebei Key Laboratory of Close-to-Nature Restoration Technology of Wetlands, Hebei University, Baoding 071002, China. Electronic address:
Imidacloprid (IMI), as an emerging pollutant, is frequently detected in pesticide wastewater. Cobalt-based single-atom catalysts (Co-SACs) doped with sulfur atoms can serve as an efficient strategy to activate peroxymonosulfate (PMS) and degrade organic pollutants. The paper employed density functional theory and computational toxicology to deeply explore the mechanism and ecotoxicity of IMI when S atoms were introduced into Co-SACs for PMS activation.
View Article and Find Full Text PDFApplication of a New Thermal Model for the Determination of London Dispersive Properties of H-β-Zeolite/Rhodium Catalysts Using New 2D Chromatographic Models.
Materials (Basel)
December 2024
Faculty of Science and Engineering, Maastricht University, P.O. Box 616, 6200 MD Maastricht, The Netherlands.
A new methodology based on the Hamieh thermal model was applied for the determination of the surface properties of solid surfaces. The new approach consisted of the accurate quantification of the London dispersive surface energy of materials using the two-dimensional inverse gas chromatography technique at infinite dilution. This technique used the notion of the net retention volume of adsorbed molecules on the solid catalysts, allowing the determination of the free energy of adsorption.
View Article and Find Full Text PDFPolyamide Microparticles with Immobilized Enological Pectinase as Efficient Biocatalysts for Wine Clarification: The Role of the Polymer Support.
Molecules
December 2024
IPC-Institute for Polymers and Composites, University of Minho, 4800-056 Guimarães, Portugal.
Free pectinase is commonly employed as a biocatalyst in wine clarification; however, its removal, recovery, and reuse are not feasible. To address these limitations, this study focuses on the immobilization of a commercial pectinolytic preparation (Pec) onto highly porous polymer microparticles (MPs). Seven microparticulate polyamide (PA) supports, namely PA4, PA6, PA12 (with and without magnetic properties), and the copolymeric PA612 MP, were synthesized through activated anionic ring-opening polymerization of various lactams.
View Article and Find Full Text PDFDesigning cellulose based biochars for CO separation using molecular simulations.
Sci Rep
January 2025
Thermodynamics Research Laboratory, School of Chemical Engineering, Iran University of Science and Technology, Tehran, 16846-13114, Iran.
This study investigates the pyrolysis mechanism of cellulose using reactive molecular dynamics simulations to prepare biochars for CO separation applications. Six biochars with densities ranging from 0.160 to 0.
View Article and Find Full Text PDFToward one-step As(III) removal in ultrafiltration with in situ BioMnO cake layer: Mechanism and feasibility insights.
Water Res
January 2025
School of Civil Engineering, Wuhan University, Wuhan, 430072, PR China. Electronic address:
Inorganic arsenic (As) is one of the most significant chemical contaminants in drinking water worldwide. Although membrane-based technologies are commonly used for As removal, they often encounter challenges including complex operation, high energy consumption, and the need for chemical addition. To address these challenges, we proposed a one-step ultrafiltration (UF) process empowered by in situ biogenic manganese oxides (BioMnO) cake layers without any additional chemicals, to treat source water contaminated with both As and manganese (Mn).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!