Introduction: The aim of this study was to evaluate if the configuration of canal orifices can predict the presence of a second mesiobuccal canal (MB2) in maxillary second molars with fused roots.

Methods: Maxillary second molars with fused roots (N = 150) were scanned in a micro-computed tomographic device (pixel size = 9 μm) and evaluated regarding the root fusion type and the incidence of the MB2 canal. The centers of the canal orifices were connected, and the angles formed by the intersection of these lines as well as their distances were measured and statistically compared (1-way analysis of variance). Specimens were then assigned to 2 groups according to the presence (n = 65) or absence (n = 50) of the MB2 canal and compared regarding the angles and interorifice distances using the Welch t test. A binary logistic regression model estimated the association between the interorifice distance, the fusion type, and the presence of the MB2 canal, whereas receiver operating characteristic curve analysis was performed to evaluate the diagnostic abilities of significant variables. The significance level was set at 5%.

Results: The most common fusion types were 1 and 6, and MB2 canal incidence was 47.3%. No statistical difference was observed in the angles or interorifice distances among teeth with different fusion types (P > .05). Distances from the mesiobuccal (MB) to the distobuccal and palatal (P) canal orifices as well as the MB and P angles were significantly higher in the presence of an MB2 canal (P < .05). A binary logistic regression model revealed that MB-distobuccal and MB-P distances were significant in the presence of an MB2 canal (P < .05). Receiver operating characteristic analysis indicated that MB-P distance had acceptable diagnostic accuracy for the prediction of MB2 canal presence. Sensitivity (specificity) calculated from the MB-P distances of 4.0, 4.5, and 5.0 mm were 89.2% (36.5%), 76.9% (58.4%), and 44.4% (71.4%), respectively.

Conclusions: MB-P interorifice distance is a strong predictor of the presence of the MB2 canal in maxillary second molars with fused roots.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.joen.2021.01.003DOI Listing

Publication Analysis

Top Keywords

mb2 canal
32
maxillary second
16
second molars
16
molars fused
16
presence mb2
16
canal
13
interorifice distance
12
fused roots
12
canal orifices
12
mb2
9

Similar Publications

Unlabelled: The first maxillary molar is one of the most difficult teeth for endodontical treatment; it presents the highest failure rates due to the impossibility of locating and treating the second mesiobuccal canal (MB2). The aim of our work was study of second mesiobuccal canal in maxillary first molar and compare obtained data with literature sources for increasing the efficiency of treatment.

Materials And Methods: The study involved 59 patients with exacerbation of chronic pulpitis or chronic periodontitis who were distributed according to age: 14-20 years, 21-30 years and 31-40 years.

View Article and Find Full Text PDF

Aim: To investigate the development of dentinal microcracks resulting from the progressive enlargement of the buccal canals of maxillary molars with and without the MB2 canal employing instruments with the same tip and four different tapers.

Methodology: Twenty maxillary molars with (n = 10) and without (n = 10) the MB2 canal underwent micro-CT scanning. Their mesiobuccal and distobuccal canals were sequentially enlarged using nickel-titanium instruments with sizes 25/.

View Article and Find Full Text PDF

Objective: This study's objective is to analyze the prevalence as well as the configuration of second mesiobuccal (MB2) in maxillary 2 molars and predict its existence based on mesiobuccal-palatal (MB-P) distance, MB-P/distobuccal-palatal (DB-P) distance ratio and mesiobuccal, distobuccal, and palatal orifice (MDP) angle with the help of cone-beam computed tomography.

Materials And Methods: The presence and absence of MB2 are noted down in 300 maxillary 2 molars. Canal configuration was observed from the orifice to the apex in the mesiobuccal root.

View Article and Find Full Text PDF

The impact of cone beam CT on outcomes associated with endodontic access cavity preparation: a controlled human analogue study using 3D-printed first maxillary molars.

Dentomaxillofac Radiol

January 2025

Division of Oral and Maxillofacial Surgery, Medicine, Pathology and Radiology, Dublin Dental University Hospital, Trinity College Dublin, Dublin, Lincoln Place, Dublin, D02 F859, Ireland.

Objectives: To identify if supplemental preoperative cone beam CT (CBCT) imaging could improve outcomes related to endodontic access cavity preparation, using 3D-printed maxillary first molars (M1Ms) in a rigorously simulated, controlled human analogue study.

Methods: Eighteen operators with 3 experience-levels took part in 2 simulated clinical sessions, 1 with and 1 without the availability of CBCT imaging, in a randomized order and with an intervening 8-week washout period. Operators attempted the location of all 4 root canals in each of 3 custom-made M1Ms (2 non-complex and 1 complex mesiobuccal [MB] canal anatomy).

View Article and Find Full Text PDF

Aim: To investigate the root number and morphology of the maxillary second molars in the Syrian population besides bilateral symmetry, and the effect of gender.

Methods: 250 Cone Beam Computed Tomography (CBCT) images (140 females, 110 males) were examined by two endodontists. The detailed analysis included the number of roots, the number of canals and their configurations, bilateral symmetry, and relation to gender.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!