Objective: This study aimed to compare the clinical outcomes in dental prophylaxis between rubber cup polishing and an air polishing system using erythritol powder, with or without prior dental plaque disclosure. Method and materials: In this single-blind, randomized, controlled, split-mouth clinical trial, healthy participants with full-mouth plaque score ≥ 60% were recruited. Quadrants in each participant were randomly assigned to four treatment groups: air polishing with prior plaque disclosure; air polishing without plaque disclosure; rubber cup polishing with prior plaque disclosure; or rubber cup polishing without plaque disclosure. Plaque scores and treatment time for each quadrant were recorded. Posttreatment satisfaction questionnaires for both the participants and operators were also completed. Results: In total, 88 participants consisting of 42 men and 46 women (mean age 23.1 ± 2.0 years) were recruited. Air polishing with prior plaque disclosure had significantly lower posttreatment marginal mean plaque score (21.7 ± 17.5%) compared to air polishing (33.5 ± 23.4%) or rubber cup polishing (34.5 ± 19.7%) without prior plaque disclosure (P < .001). Marginal mean treatment time for air polishing (325 seconds; SE = 10 seconds) was significantly shorter compared to rubber cup polishing (407 seconds; SE = 15 seconds) (P < .001). Both the participants and operators preferred air polishing over rubber cup polishing (P < .001). Conclusion: Prior plaque disclosure enhanced the effectiveness of plaque removal. Air polishing exhibited better treatment efficiency than rubber cup polishing and was the patients' and clinicians' preferred treatment modality.

Download full-text PDF

Source
http://dx.doi.org/10.3290/j.qi.a45602DOI Listing

Publication Analysis

Top Keywords

air polishing
36
plaque disclosure
36
rubber cup
32
cup polishing
28
prior plaque
20
polishing
16
plaque
13
polishing plaque
12
polishing prior
12
air
9

Similar Publications

Purpose: To assess the impact of anodization and instrumentation on titanium abutment surface characteristics (surface roughness and wettability) and biofilm formation (viability and mass).

Materials And Methods: Titanium discs were obtained from pre-milled abutment blanks made of titanium-6aluminum-7niobium alloy. Polished samples were divided into three groups: un-anodized, gold-anodized, and pink-anodized.

View Article and Find Full Text PDF

Van der Waals electrode integration is a promising strategy to create nearly perfect interfaces between metals and 2D materials, with advantages such as eliminating Fermi-level pinning and reducing contact resistance. However, the lack of a simple, generalizable pick-and-place transfer technology has greatly hampered the wide use of this technique. We demonstrate the pick-and-place transfer of prefabricated electrodes from reusable polished hydrogenated diamond substrates without the use of any sacrificial layers due to the inherent low-energy and dangling-bond-free nature of the hydrogenated diamond surface.

View Article and Find Full Text PDF

Ultra-High Sensitivity Methane Gas Sensor Based on Cryptophane-A Thin Film Depositing in Double D-Shaped Photonic Crystal Fiber Using the Vernier Effect.

Sensors (Basel)

December 2024

State Key Laboratory of Metastable Materials Science & Technology and Key Laboratory for Microstructural Material Physics of Hebei Province, School of Science, Yanshan University, Qinhuangdao 066004, China.

Methane gas leakage can lead to pollution problems, such as rising ambient temperature. In this paper, the Vernier effect of a double D-shaped photonic crystal fiber (PCF) in a Sagnac interferometer (SI) is proposed for the accurate detection of mixed methane gas content in the gas. The optical fiber structure of the effective sensing in the sensing SI loop and the effective sensing in the reference SI loop are the same.

View Article and Find Full Text PDF

Implant Surface Decontamination Methods That Can Impact Implant Wettability.

Materials (Basel)

December 2024

Department of Prosthodontics and Digital Technology, School of Dental Medicine, Stony Brook University, Stony Brook, NY 11794, USA.

This review addresses the effects of various decontamination methods on the wettability of titanium and zirconia dental implants. Despite extensive research on surface wettability, there is still a significant gap in understanding how different decontamination techniques impact the inherent wettability of these surfaces. Although the literature presents inconsistent findings on the efficacy of decontamination methods such as lasers, air-polishing, UV light, and chemical treatments, the reviewed studies suggest that decontamination alters in vitro hydrophilicity.

View Article and Find Full Text PDF

Gingival Margin Damage During Supragingival Dental Polishing by Inexperienced Operator-Pilot Study.

J Funct Biomater

December 2024

Department of Veterinary Anatomy, Histology and Embryology, Faculty of Veterinary Medicine, Trakia University, 6000 Stara Zagora, Bulgaria.

Background: Supragingival polishing is a crucial part of nonsurgical periodontal therapy. In recent years, air polishing has been used for this purpose, introducing different polishing powders. The purpose of the following study was to investigate the damage to the gingival margin during air polishing by an inexperienced operator.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!