Personalized Mass Production by Hybridization of Additive Manufacturing and Injection Molding.

The new trend in the composites industry, as dictated by Industry 4.0, is the personalization of mass production to match every customer's individual needs. Such synergy can be achieved when several traditional manufacturing techniques are combined within the production of a single part. One of the most promising combinations is additive manufacturing (AM) with injection molding. AM offers higher production freedom in comparison with traditional techniques. As a result, even very sophisticated geometries can be manufactured by AM at a reasonable price. The bottleneck of AM is the production rate, which is several orders of magnitude slower than that of traditional plastic mass production technologies. On the other hand, injection molding is a manufacturing technique for high-volume production with little possibility of customization. The customization of injection-molded parts is usually very expensive and time-consuming. In this research, we offered a solution for the individualization of mass production, which includes 3D printing a baseplate with the subsequent overmolding of a rib element on it. We examined the bonding between the additive-manufactured component and the injection-molded component. As bonding strength between the coupled elements is significantly lower than the strength of the material, we proposed five strategies to improve bonding strength. The strategies are optimizing the printing parameters to obtain high surface roughness, creating an infill density in fused filament fabrication (FFF) parts, creating local infill density, creating microstructures, and incorporating fibers into the bonding area. We observed that the two most effective methods to increase bonding strength are the creation of local infill density and the creation of a microstructure at the contact area of FFF-printed and injection-molded elements. This increase was attributed to the porous structures that both methods created. The melt during injection molding flowed into these pores and formed micro-mechanical interlocking.