A family of rare-earth complexes bearing diarylamido-based pincer ligands with phosphino-, phenylthio- and quinolino-sidearms have been synthesized and fully characterized. Upon activation by [PhC][B(CF)], the scandium (P-Sc and S-Sc) and yttrium complexes (P-Y and S-Y) could catalyze the polymerization of isoprene with cis-1,4 selectivity (up to 98.8%), while the lutetium analogues P-Lu and S-Lu produced trans-1,4 selective polyisoprene (up to 83.3%). Density functional theory (DFT) calculations were carried out to clarify the mechanisms for the metal-dependent stereoselective (cis to trans) polymerization of isoprene catalyzed by P-Sc, P-Y and P-Lu, suggesting that kinetically and thermodynamically more favorable insertion-isomerization during chain propagation is the key reason for P-Lu catalyzed trans-stereoselective isoprene polymerization.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/d0dt04040a | DOI Listing |
Macromol Rapid Commun
November 2024
Dipartimento di Chimica e Biologia "Adolfo Zambelli", Università degli Studi di Salerno, Via Giovanni Paolo II, Fisciano, SA, 84084, Italy.
The advancement of stereoregular polymerization techniques for linear 1,3-dienes has enabled the production of polymers with precise stereocontrol, influencing their physical and chemical properties significantly. While 1,3-butadiene and isoprene yield diverse stereoregular polymers, cyclic dienes have received less attention due to catalyst challenges and limited application in the rubber industry. However, the growing interest in bio-based monomers, particularly those derived from terpenes and terpenoids, has revitalized interest in cyclic monomers with conjugated double bonds.
View Article and Find Full Text PDFDalton Trans
December 2024
Key Laboratory of Engineering Plastics and Beijing National Laboratory for Molecular Science, Institute of Chemistry, Chinese Academy of Sciences, Beijing 100190, China.
The coordination sphere and steric variations in iron catalysts present a fascinating strategy for adjusting monomer regio- and stereoselective enchainment, leading to the development of novel polymer structures in isoprene polymerization. This study investigates a range of iron complexes with variations in the coordination spheres (bidentate and tridentate) and steric/electronic properties of side arms to evaluate their impact on isoprene polymerization. X-ray analysis revealed that the tridentate Fe-NMe2 complex has a dinuclear structure with a -O bridge, where each iron center is monoligated in an octahedral geometry.
View Article and Find Full Text PDFACS Appl Mater Interfaces
November 2024
Institute of Systems and Robotics, Department of Electrical Engineering, University of Coimbra, Coimbra 3030-290, Portugal.
Liquid metal (LM)-based composites hold promise for soft electronics due to their high conductivity and fluidic nature. However, the presence of α-GaO and GaOOH layers around LM droplets impairs conductivity and performance. We tackle this issue by replacing the oxide layer with conductive silver (Ag) using an ultrasonic-assisted galvanic replacement reaction.
View Article and Find Full Text PDFMacromol Rapid Commun
October 2024
Helmholtz-Zentrum Hereon, Institute of Membrane Research, Max-Planck-Straße 1, 21502, Geesthacht, Germany.
In this study, reversible addition-fragmentation chain- transfer (RAFT) polymerization combined with the polymerization-induced self-assembly (PISA) technique is used to synthesize polyisoprene (PI)-based block and random copolymers with polystyrene (PS), aiming for high molecular weight and monomer conversion. The focus is to optimize the polymerization conditions to overcome the existing challenge of cross-linking and Diels-Alder reactions during the polymerization of isoprene, which typically constrain the reaction conversion and molecular weight of the final polymers. Using a poly(methacrylic acid) (PMAA) macroRAFT agent synthesized in ethanol at 80 °C, random and block copolymers of PS-PI with a target molecular weight of 50 000 g mole and a high monomer conversion of ≈80% are achieved under optimized conditions in water-emulsion at 35 °C.
View Article and Find Full Text PDFPolymers (Basel)
October 2024
MOE Key Laboratory of Macromolecule Synthesis and Functionalization, Department of Polymer Science and Engineering, Zhejiang University, Hangzhou 310027, China.
It is highly desired yet challenging to develop advanced elastomers with excellent mechanical properties, including high strength and toughness. In this work, strong and tough rubber/rubber compound vulcanizates were facilely prepared by blending ethylene-propylene-methylene (EPM) and isoprene rubber (IR) together with dicumyl peroxide (DCP) and subsequent vulcanization, since both EPM and IR can be vulcanized synchronously by DCP and the well-crosslinked structure of EPM/IR vulcanizate presented a stable phase separation state. By tuning their composition, EPM/IR vulcanizates could present remarkably improved mechanical strength and toughness, as well as excellent energy dissipation and deformation recovery abilities.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!