Evaluation of a Subcutaneously Injectable Implant with a Low-Power Photoplethysmography ASIC for Animal Monitoring.

Sensors (Basel)

Department of Electrical and Computer Engineering, NC State University, Raleigh, NC 27695-7911, USA.

Published: December 2020

Photoplethysmography is an extensively-used, portable, and noninvasive technique for measuring vital parameters such as heart rate, respiration rate, and blood pressure. The deployment of this technology in veterinary medicine has been hindered by the challenges in effective transmission of light presented by the thick layer of skin and fur of the animal. We propose an injectable capsule system to circumvent these limitations by accessing the subcutaneous tissue to enable reliable signal acquisition even with lower light brightness. In addition to the reduction of power usage, the injection of the capsule offers a less invasive alternative to surgical implantation. Our current prototype combines two application-specific integrated circuits (ASICs) with a microcontroller and interfaces with a commercial light emitting diode (LED) and photodetector pair. These ASICs implement a signal-conditioning analog front end circuit and a frequency-shift keying (FSK) transmitter respectively. The small footprint of the ASICs is the key in the integration of the complete system inside a 40-mm long glass tube with an inner diameter of 4 mm, which enables its injection using a custom syringe similar to the ones used with microchip implants for animal identification. The recorded data is transferred wirelessly to a computer for post-processing by means of the integrated FSK transmitter and a software-defined radio. Our optimized LED duty cycle of 0.4% at a sampling rate of 200 Hz minimizes the contribution of the LED driver (only 0.8 mW including the front-end circuitry) to the total power consumption of the system. This will allow longer recording periods between the charging cycles of the batteries, which is critical given the very limited space inside the capsule. In this work, we demonstrate the wireless operation of the injectable system with a human subject holding the sensor between the fingers and the functionality of the subcutaneous sensing on a pilot study performed on anesthetized rat subjects.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7766824PMC
http://dx.doi.org/10.3390/s20247335DOI Listing

Publication Analysis

Top Keywords

fsk transmitter
8
evaluation subcutaneously
4
subcutaneously injectable
4
injectable implant
4
implant low-power
4
low-power photoplethysmography
4
photoplethysmography asic
4
asic animal
4
animal monitoring
4
monitoring photoplethysmography
4

Similar Publications

Body channel communication (BCC) has become a promising candidate in wireless body area networks (WBAN) due to its advantages in energy efficiency and security. However, BCC transceivers face two challenges: diverse application requirements and varying channel conditions. To overcome these challenges, this article proposes a re-configurable architecture for BCC transceivers (TRXs), whose key parameters and communication protocols can be software-defined (SD) according to the requirements.

View Article and Find Full Text PDF

The article presents for the first time a pill-based ingestible electronics with CMOS integrated multiplexed fluorescence bio-molecular sensor arrays, bi-directional wireless communication and packaged optics in a FDA-approved capsule for in-vivo bio-molecular sensing. The silicon chip integrates both the sensor array, and the ultra-low-power (ULP) wireless system that allows offloading sensor computing to an external base station that can reconfigure the sensor measurement time, and its dynamic range, allowing optimized high sensitivity measurement under low power consumption. The integrated receiver achieves -59 dBm receiver sensitivity dissipating 121 µW of power.

View Article and Find Full Text PDF

The 'power frequency splitting' phenomenon is widely observed over critical coupling conditions in the wireless power transfer system. Frequency splitting occurs in the voltage gain and power delivered to the load (PDL) curve but not in the end-to-end power transfer efficiency curve. This brief has considered the mutual inductance model to analyze the relationship between characteristic frequencies and circuit parameters in the wireless series-parallel system.

View Article and Find Full Text PDF

Full-duplex enabled wireless power transfer system via textile for miniaturized IMD.

Biomed Eng Lett

August 2022

Department of Electronic Engineering, Hanyang University, Seoul, 04763 South Korea.

Full-duplex (FD) enabled wireless power transfer (WPT) system via textile for miniaturized IMD is presented. By utilizing the battery-free near-field communication (NFC) method, the system realizes wireless power and data transmission without a bulky battery or energy harvester which can diminish the physical size of implantable medical device (IMD). Moreover, using textile as a medium of power transmission, the system overcomes the drawback and extends the limited effective range of the NFC method.

View Article and Find Full Text PDF

A sub-1GHz transmitter (TX) integrated chip (IC) with ultra-low power consumption and moderately high adjacent channel power rejection (ACPR) is presented for in-body bio-sensing applications. The 400 MHz 12-phase digital power amplifier (DPA) is implemented with the proposed 16QAM modulation scheme to improve the energy efficiency. The TX IC also contains a 900 MHz FSK TX realized with a symmetrical edge-combiner, which can be used in the low accuracy mode.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!