Introduction: Reconstruction of the scapho-lunate (SL) ligament is still challenging. Many different techniques, such as capsulodesis, tendon graft and bone-ligament-bone graft have been described to stabilize reducible SL dissociation. If primary ligament repair alone is not possible, an additional stabilizer is needed to achieve scapho-lunate stability. A new local bone-ligament transfer using half of the radio-luno-triquetral ligament is performed. The direction of traction of the transposed ligament is very similar to the original ligament. Ideal tension can be attained by fixation of the bone block at the dorsal ridge of the scaphoid. The biomechanical stability of this bone-ligament transfer shall be examined biomechanically.
Material And Methods: Computed tomography imaging was performed using eight cadaveric forearms with a defined position of the wrist. Axial load was accomplished with tension springs attached to the extensor and flexor tendons. Three series ([a] native, [b] divided SL ligament and [c]) after reconstruction with bone-ligament transfer] were reconstructed three-dimensionally to determine the angles between radius, scaphoid and lunate. The radial distal part including a bone fragment of the radio-luno-triquetral ligament was transferred from its insertion at the distal edge of the radius to be attached to the dorsal ridge of the scaphoid.
Results: SL gap was widened after its transection. Average SL distance was 6.6 ± 1.6 mm. After ligament reconstruction, the gap could be narrowed significantly to 4.2 mm (± 0.7 mm). The movement of the scaphoid and lunate showed significant changes, especially in wrist flexion, fist closure and radial deviation. These deviations could be corrected by the bone ligament transfer.
Conclusion: Reconstruction of a transected SL ligament with a bone-ligament transfer from the radio-luno-triquetral ligament reduces SL dissociation under axial load. The described surgical technique causes low donor-side morbidity and can be considered in addition to improve stability if SL ligament suture alone does not appear sufficient.
Level Of Evidence: Level II, therapeutic investigating experimental study.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7886774 | PMC |
http://dx.doi.org/10.1007/s00402-020-03690-2 | DOI Listing |
J Wrist Surg
June 2022
Division of Upper Limb and Research, Department of Orthopaedic Surgery, Flinders University and Flinders Medical Centre, Adelaide, South Australia.
Volar ulnar corner fractures are a subset of distal radius fractures that can have disastrous complications if not appreciated, recognized, and appropriately managed. The volar ulnar corner of the distal radius is the "critical corner" between the radial calcar, distal ulna, and carpus and is responsible for maintaining stability while transferring force from the carpus. Force transmitted from the carpus to the radial diaphysis is via the radial calcar.
View Article and Find Full Text PDFSci Rep
December 2020
Facultad de Ciencias de la Salud, Universidad de Zaragoza, C/Domingo Miral S/N, 50009, Zaragoza, Zaragoza, Spain.
Capacitive-resistive electric transfer therapy is used in physical rehabilitation and sports medicine to treat muscle, bone, ligament and tendon injuries. The purpose is to analyze the temperature change and transmission of electric current in superficial and deep knee tissues when applying different protocols of capacitive-resistive electric transfer therapy. Five fresh frozen cadavers (10 legs) were included in this study.
View Article and Find Full Text PDFArch Orthop Trauma Surg
February 2021
Department of Hand Surgery, University Hospital of Bern, 3010, Bern, Switzerland.
Introduction: Reconstruction of the scapho-lunate (SL) ligament is still challenging. Many different techniques, such as capsulodesis, tendon graft and bone-ligament-bone graft have been described to stabilize reducible SL dissociation. If primary ligament repair alone is not possible, an additional stabilizer is needed to achieve scapho-lunate stability.
View Article and Find Full Text PDFBiotechnol Bioeng
October 2017
Trinity Centre for Bioengineering, Trinity Biomedical Sciences Institute, Trinity College Dublin, Dublin, Ireland.
Regenerating damaged tissue interfaces remains a significant clinical challenge, requiring recapitulation of the structure, composition, and function of the native enthesis. In the ligament-to-bone interface, this region transitions from ligament to fibrocartilage, to calcified cartilage and then to bone. This gradation in tissue types facilitates the transfer of load between soft and hard structures while minimizing stress concentrations at the interface.
View Article and Find Full Text PDFActa Biomater
July 2017
Cambridge University Engineering Dept, The Nanoscience Centre, 11 JJ Thomson Avenue, Cambridge CB3 0FF, UK. Electronic address:
Unlabelled: Bone-tendon, bone-ligament and bone-cartilage junctions are multi-tissue interfaces that connect materials that differ by two orders of magnitude in mechanical properties, via gradual variations in mineral content and matrix composition. These sites mediate load transfer between highly dissimilar materials and are consequently a primary site of injury during orthopedic failure. Given the large incidence rate and the lack of suitable surgical solutions for their regeneration or repair, characterization of their natural structure and subsequent replication through tissue engineering is important.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!