A proposal for producing calculated noise mapping defining the sound power levels of roads by street stratification.

The European Noise Directive proposes using strategic noise maps as tools to assess populations affected by environmental noise. It recommends using computational methods instead of in situ measurements when possible. A sound source's emission power is an important factor in the calculation of noise indicators. For traffic noise, this parameter is usually defined based on vehicle flow considering an emission spectrum that depends on the type of vehicle and its speed. This study analysed the possibility of using the categorisation method to propose an alternative method of defining a sound source's emission power to develop noise maps. This was accomplished using previously published values of the emission power per unit length. Another method is also proposed that estimates traffic flows. To verify their estimation capacity, the results of both methods were compared with the values obtained from in situ measurements. The results demonstrated similar uncertainties in both methods and were in the range of expected average uncertainties compared to the results obtained by calculating a noise map with the measured experimental values. In particular, for the differences between calculations and measurements, in absolute values, the mean uncertainties were approximately 2 dBA in estimating different long-term noise indicators. For the differences, the mean of the uncertainties obtained via the categorisation method did not present significant differences for the null value for all the analysed noise indicators. Street stratification is a rapid and low-cost approach for road traffic noise mapping without increasing uncertainties.