In this study, two sets of methyl-coated non-porous and mesoporous amorphous silica materials of two target sizes (100 and 300 nm; 10-844 m/g) were used to investigate the potential role of specific surface area (SSA) and porosity on the oral toxicity in mice. Female Swiss mice were administered by oral gavage for 5 consecutive days. Two silica dose levels (100 and 1000 mg/kg b.w.) were tested for all four materials. All dispersions were characterized by transmission electron microscopy (TEM) and Nanoparticle tracking analysis (NTA). Batch dispersions of porous silica were rather unstable due to agglomeration. Animals were sacrificed one day after the last administration or after a three-week recovery period. No relevant toxicological effects were induced by any of the silica materials tested, as evaluated by body weight, gross pathology, relative organ weights (liver, spleen, kidneys), hematology, blood biochemistry, genotoxicity (Comet assay in jejunum cells and micronucleus test in peripheral blood erythrocytes), liver and small intestine histopathology, and intestinal inflammation. The presence of silica particles in the intestine was evaluated by a hyperspectral imaging microscopy system (CytoViva) using histological samples of jejunum tissue. Silica spectral signatures were found in jejunum samples with all the treatments, but only statistically significant in one of the treatment groups.

Download full-text PDF

Source
http://dx.doi.org/10.1080/17435390.2020.1818325DOI Listing

Publication Analysis

Top Keywords

non-porous mesoporous
8
toxicity mice
8
silica materials
8
silica
7
short-term oral
4
oral administration
4
administration non-porous
4
mesoporous silica
4
silica induce
4
induce local
4

Similar Publications

Silica materials, natural and synthetic variants, represent a promising material for the application in heterogeneous organocatalysis due to their readily modifiable surface and chemical inertness. To achieve high catalyst loadings, usually, porous carriers with high surface areas are used, such as silica monoliths or spherical particles for packed bed reactors. While these commercial materials were shown to be efficient supports, their synthesis is elaborate, and thus less complex and cheaper alternatives are of interest, especially considering scaling up for potential applications.

View Article and Find Full Text PDF

Hydroxyapatite (HAP) porous microspheres with very high specific surface area and drug loading capacity, as well as excellent biocompatibility, have been widely used in tumour therapy. Mg is considered to be a key factor in bone regeneration, acting as an active agent to stimulate bone and cartilage formation, and is effective in accelerating cell migration and promoting angiogenesis, which is essential for bone tissue repair, anti-cancer, and anti-infection. In this study, abalone shells from a variety of sources were used as raw materials, and Mg-doped abalone shell-derived mesoporous HAP microspheres (Mg-HAP) were prepared by hydrothermal synthesis as Mg/ icariin smart dual delivery system (ICA-Mg-HAP, IMHA).

View Article and Find Full Text PDF

This study aimed to investigate the surface hardness, monomer conversion, surface roughness, boron release, and water sorption-solubility properties of experimental resin composites (RC) containing hydroxyapatite nanocarriers (HAP) loaded with different boron compounds, in comparison to a conventional RC. In this study, boron nitride and 4-borono-L-phenylalanine were loaded into mesoporous and nonporous HAP. 1% boron-nanocarrier complexes were added to a conventional resin-composite content.

View Article and Find Full Text PDF

MXenes are known for their exceptional electrical conductivity and surface functionality, gaining interest as promising anode materials for Li-ion batteries. However, conventional 2D multilayered MXenes often exhibit limited electrochemical applicability due to slow ion transport kinetics and low structural stability. Addressing these challenges, this study develops a 3D flower-type double transition metal MXene, MoTiCCl, with precisely engineered in-plane mesoporosity using HF-free Lewis acid-assisted molten salt method, coupled with intercalation and freeze-drying.

View Article and Find Full Text PDF

Two-electron oxygen reduction reaction (2e ORR) is a promising alternative to energy-intensive anthraquinone process for hydrogen peroxide (HO) production. Metal-free nanocarbon materials have garnered intensive attention as highly prospective electrocatalysts for HO production, and an in-depth understanding of their porous structure and active sites have become a critical scientific challenge. The present research investigates a range of porous carbon catalysts, including non-porous, microporous, and mesoporous structures, to elucidate the impacts of porous structures on 2e ORR activity.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!