The primary reasons for myocardial infarction (MI) are pericarditis, arrhythmia, and heart failure, causing predominant deaths worldwide. Patients need a potential diagnostic system and treatment before cardiomyocyte damage. Cardiac biomarkers are released from myocytes immediately after a heart attack. Troponin is an efficient biomarker released from dead cells within a few hours. Aptamers are artificial antibodies used effectively in the biosensor field for biomarker detection. Along with aptamers, the application of nanomaterials is also expected to enhance the detection limits of biosensors. In this investigation, selected aptamers against cardiac troponin I (cTnI) were conjugated with gold nanoparticles (GNPs) to diagnose MI and compared with an aptamer-only control group on an interdigitated electrode surface. Based on electroanalysis, cTnI was detected at concentrations as low as 1 fM, and the detection limit improved to 100 aM when the aptamer was conjugated with GNP. In addition, aptamer-GNP conjugates increased the current level at the tested concentrations of cTnI. Control experiments with noncomplementary aptamers and relevant proteins did not result in notable changes in the current, demonstrating the selective detection of cTnI.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7558037 | PMC |
http://dx.doi.org/10.1021/acsomega.0c03260 | DOI Listing |
Proc Natl Acad Sci U S A
January 2025
Electronics Sciences and Technology Division, United States Naval Research Laboratory, Washington, DC 20375.
This study presents the direct measurement of proton transport along filamentous , or cable bacteria. Cable bacteria are filamentous multicellular microorganisms that have garnered much interest due to their ability to serve as electrical conduits, transferring electrons over several millimeters. Our results indicate that cable bacteria can also function as protonic conduits because they contain proton wires that transport protons at distances >100 µm.
View Article and Find Full Text PDFACS Sens
January 2025
School of Electrical and Electronic Engineering, Yonsei University, Seoul 03722, Republic of Korea.
Bioelectronic face masks can easily collect biomarkers in saliva, in which free cortisol is abundant. However, conventional bioelectronic face masks involve significant challenges in terms of permeability and inhalation due to their nonpermeable film-type structure. Herein, we introduce a flexible and permeable nanomesh-based wearable biosensor designed for bioelectronic face masks that monitor cortisol levels.
View Article and Find Full Text PDFSensors (Basel)
December 2024
Department of Applied Physics, National Defense Academy, Hashirimizu 1-10-20, Yokosuka 239-0802, Kanagawa, Japan.
Dielectrophoresis (DEP) cell separation technology is an effective means of separating target cells which are only marginally present in a wide variety of cells. To develop highly efficient cell separation devices, detailed analysis of the nonuniform electric field's intensity distribution within the device is needed, as it affects separation performance. Here we analytically expressed the distributions of the electric field and DEP force in a parallel-plate cell separation DEP device by employing electrostatic analysis through the Fourier series method.
View Article and Find Full Text PDFSensors (Basel)
December 2024
Department of Physics, Yonsei University, Seoul 03722, Republic of Korea.
The rapid and reliable detection of pathogenic bacteria remains a significant challenge in clinical microbiology. Consequently, the demand for simple and rapid techniques, such as antimicrobial peptide (AMP)-based sensors, has recently increased as an alternative to traditional methods. Melittin, a broad-spectrum AMP, rapidly associates with the cell membranes of various gram-positive and gram-negative bacteria.
View Article and Find Full Text PDFNanomaterials (Basel)
December 2024
Quantum Nano Centre, Department of Chemical Engineering, University of Waterloo, Waterloo, ON N2L 3G1, Canada.
Laser conversion of commercial polymers to laser-induced graphene (LIG) using inexpensive and accessible CO lasers has enabled the rapid prototyping of promising electronic and electrochemical devices. Frequently used to pattern interdigitated supercapacitors, few approaches have been developed to pattern batteries-in particular, full cells. Herein, we report an LIG-based approach to a planar, interdigitated Li-S battery.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!