Influence of unsaturation of hydrocarbons on the characteristics and carcinogenicity of soot particles.

J Anal Appl Pyrolysis

Department of Mechanical Engineering, University College London, Torrington Place, London, WC1E 7JE, United Kingdom.

Published: October 2020

This paper concerns the effect of unsaturation of hydrocarbons (single, double, and triple bonds) on soot particle characteristics (mass, number, and size) and on the carcinogenicity of soot particles. The soot particles were produced from oxygen-free pyrolysis of five hydrocarbons, namely: propane, propylene, ethane, ethylene, and acetylene. The characteristics of soot particles were measured with the aid of a differential mobility spectrometer (Cambustion-DMS-500) and measurement of soot mass concentration was confirmed using gravimetric filter measurements. The soot particle carcinogenicity was estimated from the emission quantities of total polyaromatic hydrocarbons (PAHs) and the toxicity equivalent factor (TEF) of each PAH. Oxygen-free pyrolysis of the hydrocarbon fuels was conducted in a laminar tube reactor within the temperature range of 1050 -1350oC at a constant nitrogen flow rate of 20 L/min and constant fuel flow rate of 1% (vol) on carbon-1 basis. The experimental results showed that increasing unsaturation of fuels from single to double and to triple bonds increased the mass concentration, particle size, number concentration, and carcinogenicity of soot particle notably at the initial temperature of 1050 oC. Increase in the pyrolysis temperature of the tube reactor from 1050 - 1350oC, increased the mass concentration and sizes of the soot particle while the number concentration and carcinogenicity of the soot particle decreased. There was a positive correlation between the soot particle number and the corresponding soot particle carcinogenicity, while a negative correlation was observed between the soot particle mass and size with soot particle carcinogenicity regardless of the pyrolysis temperature examined. The potential implication of these observations is that, low-temperature combustion (LTC) applications, aimed at reducing emissions of soot and NOx, could produce higher soot particle number concentration of higher carcinogenicity.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7419260PMC
http://dx.doi.org/10.1016/j.jaap.2020.104900DOI Listing

Publication Analysis

Top Keywords

soot particle
40
soot
16
carcinogenicity soot
16
soot particles
16
mass concentration
12
particle carcinogenicity
12
number concentration
12
particle number
12
particle
11
unsaturation hydrocarbons
8

Similar Publications

The removal of soot particles via high-performance catalysts is a critical area of research due to the growing concern regarding air pollution. Among various potential catalysts suitable for soot oxidation, cerium oxide-based materials have shown considerable promise. In this study, CeO samples obtained using a range of preparation methods (including hydrothermal synthesis (HT), sonochemical synthesis (SC), and hard template synthesis (TS)) were tested in soot combustion.

View Article and Find Full Text PDF

Particulate matter (PM) is a major component of ambient air pollution. PM exposure is linked to numerous adverse health effects, including chronic lung diseases. Air quality guidelines designed to regulate levels of ambient PM are currently based on the mass concentration of different particle sizes, independent of their origin and chemical composition.

View Article and Find Full Text PDF

Enhancing Catalytic Removal of Autoexhaust Soot Particles via the Modulation of Interfacial Oxygen Vacancies in Cu/CeO Catalysts.

Environ Sci Technol

January 2025

State Key Laboratory of Heavy Oil Processing, Key Laboratory of Optical Detection Technology for Oil and Gas, College of Science, China University of Petroleum, Beijing 102249, PR China.

The purification efficiency of autoexhaust carbon strongly depends on the heterogeneous interface structure between active metal and oxide, which can modulate the local electronic structure of defect sites to promote the activation of reactant molecules. Herein, the high-dispersion CuO clusters supported on the well-defined CeO nanorods were prepared using the complex deposition slow method. The formation of heteroatomic Cu-O-Ce interfacial structural units as active sites can capture electrons to achieve activation of the NO and O molecules.

View Article and Find Full Text PDF

A Review of Laboratory Studies on the Heterogeneous Chemistry of NO: Mechanisms and Uptake Kinetics.

J Phys Chem A

January 2025

State Key Joint Laboratory of Environment Simulation and Pollution Control, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences, Beijing 100085, China.

NO is a significant primary atmospheric pollutant that plays a key role in atmospheric chemistry. It serves as a crucial precursor to photochemical smog, acid rain, and secondary particulate matter and is instrumental in determining the atmospheric oxidation capacity. In this review, we focus on the heterogeneous chemistry of NO, which has been demonstrated to significantly influence the sources and sinks of various nitrogen-containing species through field measurements and model simulations.

View Article and Find Full Text PDF

Cocombustion with biomass tar is a potential method for NO reduction during fossil fuel combustion. In this work, the molecular dynamic method based on the reactive force field was used to study the NO reduction by phenol, which is a typical tar model compound. Results indicate that phenol undergoes significant decomposition at 3000 K, resulting in the formation of small molecular fragments accompanied by the generation of large molecular, network-structured soot particles.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!