Several health benefits are currently attributed to natural pigments that give fruit and vegetables their inherently colorful properties. Color measurements might therefore serve as quick indicators of the potential health-promoting properties of such foods. Nevertheless, the relationship between color and pigment content depends on the type of matrix and pigment, as well as the factors affecting their interaction, which calls for further investigation. Hence, the aim of the present study is to investigate the relationship between color parameters and betalain content in three commonly consumed beetroot products (beetroot juice, beetroot puree and whole beetroot), subjected to thermal treatment. Our results showed a negative correlation between the total betalain content and the color parameters L*, a*, b*, chroma, and hue angle in beetroot juice, beetroot puree and whole beetroot. Two chromatic parameters, a* and chroma, are proposed as the best descriptors for the betalain concentrations of these products. Likewise, the tristimulus L/ab combination for the juice is also suggested as a good descriptor. Our findings highlighted that the relationship between color and total betalain content depended on the beetroot product under assessment, with the strongest correlations found for the juice. Squeezed beetroot was therefore suggested as an alternative to improve this relationship in more complex matrices such as whole cooked beetroots. Useful information from color determination sheds light on the relationship between color and betalain pigments in beetroot, suggesting that color determination could be used as an indicator of betalain content.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7374684 | PMC |
http://dx.doi.org/10.1007/s13197-020-04363-z | DOI Listing |
Cureus
December 2024
Department of Prosthodontics, Graduate School of Dentistry, Showa University, Tokyo, JPN.
Purpose: This study aims to evaluate the effects of taper angle and the number of insertion-removal cycles on the retention force of 4 mol% yttria partially stabilized zirconia (4Y-PSZ) double crowns over time.
Materials And Methods: Primary and secondary crowns were fabricated using 4Y-PSZ with taper angles of 2°, 4°, and 6° (n=15). Retention force during crown removal was measured after applying 50-N and 100-N loads.
J Dent
January 2025
Clinic of General-, Special Care- and Geriatric Dentistry, Center for Dental Medicine, University of Zurich, Zurich, Switzerland. Electronic address:
Objective: This study aimed to investigate the resin compounds from CAD-CAM 3D-printed denture resins, focusing on the identification and classification of free monomers and other components. The primary objective was to determine the chemical profile of these 3D-prinding resin materials.
Methods: Four 3D-printed denture resins, two base materials (1: DentaBASE, Asiga Ltd.
Int J Biol Macromol
January 2025
Faculty of Polymer Engineering and Color Technology, Amirkabir University of Technology, Tehran, Iran.
In this research, tartaric acid was used to enhance the hydroxyapatite coating on AZ31 Mg alloy substrate through post-treatment and direct addition methods, and the corrosion resistance and biological activity of the samples were investigated. The parameters of concentration, immersion time, and pH of the coating solution were optimized by Electrochemical Impedance Spectroscopy (EIS) and Direct Current (DC) Polarization techniques. According to EIS results in the post-treatment method, tartaric acid with a concentration of 1 g/L, pH = 9 and immersion time of 2 min, increased the corrosion resistance of hydroxyapatite coating from 3630 to about 18,763 Ω.
View Article and Find Full Text PDFChem Biol Interact
January 2025
Department of Community Dental Health, Faculty of Dental Sciences, University of Sri Jayewardenepura, Gangodawila, Nugegoda, Sri Lanka.
Betel quid contains two major ingredients; Areca catechu and Piper betel, often consumed with slaked lime, tobacco, certain flavouring agents, colouring agents, herbs, and spices according to personal preferences. The areca nut alkaloids (arecoline, arecaidine, guvacine, and guvacoline), and tobacco alkaloids (nicotine, nor-nicotine) undergo nitrosation during chewing in the oral cavity with the presence of nitrite and thiocyanate and endogenously. Among the nitrosation products generated areca nut-derived nitrosamine (ADNA): 3-(methylnitrosamino) Propionitrile (MNPN) and the two tobacco-specific nitrosamines (TSNAs); N'-nitrosonornicotine (NNN) and 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanone) (NNK) are considered Group 1 human carcinogens.
View Article and Find Full Text PDFSpectrochim Acta A Mol Biomol Spectrosc
January 2025
Materials Chemistry Research Center, Department of Chemistry, Faculty of Science, Khon Kaen University, Khon Kaen 40002 Thailand. Electronic address:
A zinc(II) coordination polymer, [Zn(Hdhtp)(2,2'-bpy)(HO)] (1), has been utilized as a dual-mode luminescence-colorimetric sensor (Hdhtp = 2,5-dihydroxy terephthalate and 2,2'-bpy = 2,2'-bipyridine). The presence of hydroxyl groups in Hdhtp can promote excited-state intra- and intermolecular proton transfer (ESIPT) phenomena. Therefore, compound 1, which displays high stability in aqueous environments, exhibits a strong green-yellow photoluminescence.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!