Solids management in freshwater-recirculating aquaculture systems: Effectivity of inorganic and organic coagulants and the impact of operating parameters.

Coagulants are widely used for solids (uneaten food, faeces, etc.) management in recirculating aquaculture systems (RAS), but no recent research has been performed on the effectiveness of different coagulants in treatment of aquaculture sludge. This study examined the effectivity of selected inorganic (polyaluminium chloride, PAC) and organic products (polyamine- and starch-based) as coagulant agents for solids management in RAS. Reductions in residual concentrations of total phosphorus (tot-P), phosphate‑phosphorus (PO-P), suspended solids (SS) total nitrogen (tot-N), nitrate‑nitrogen (NO-N), ammonium‑nitrogen (NH-N), aluminium (Al) and chemical oxygen demand (COD) in reject water were determined. The effect of process parameters (coagulant type, dose, mixing and sedimentation time) on sludge treatment was also evaluated. The PAC products tested were most effective at concentrating pollutants (Tot-P, PO-P, SS, COD) in RAS sludge into the solid phase. The organic products tested, especially a high-molecular-weight polyamine product (pAmine1), achieved good performance and can be considered a valid alternative to inorganic salts. At optimum dose, PAC (dose 32 mg/L) and pAmine1 (dose 15 mg/L) removed, respectively, 99.4% and 82.8% of turbidity, 98.2% and 65.4% of PO-P and 97.7% and 73.6% of SS. The mixing time applied in flocculation and the time allowed for sedimentation had significant effects on coagulant performance, with the organic coagulants being most affected. Flocculation times of 5-15 min and sedimentation times of 15-60 min showed good results and can be used as a starting point in process optimisation with both inorganic and organic coagulants. The use of coagulants for treatment of RAS sludge enhances flock formation and improves particle settling characteristics, substantially decreasing nutrient, organics and solids concentration in reject water.