The research was aimed at studying the efficiency of a nanoscale alloy of copper (Cu) and zinc (Zn) to be used as a mineral additive for feeding broiler chickens, compared to inorganic and organic forms of these elements. Biochemical studies of the blood serum were performed using an automated analyzer. The mineral composition was determined by atomic emission and mass spectrometry (MS-ISP). The study was performed on broiler chickens of cross Smena 7 ( 72) in the conditions of a vivarium. There were 3 treatment groups with 24 chickens in each. Replacing the inorganic form of mineral supplements with the nanosized alloy resulted in a positive productive effect, with a tendency to increasing the content of serum protein. The nanoscale form of metals improved ( ≤ 0.05) the activity of aminotransferases. At the same time, the liver microstructure of experimental groups is similar to that of the control. There was a moderate plethora and poor polymorphoncellular infiltration around the interlobular triads with a clear morphological organization of the stromal and parenchymal components of the liver. However, the lack of oxidative stress was confirmed by the dynamics of catalase (CT), total superoxide dismutase (T-SOD) and malondialdehyde (MDA) levels, and the concentrations of which did not exceed the reference level. Replacing Cu and Zn sulfates with the nanoscale alloy (group 1) and organic form (group 2) of these elements in the diet of broiler chickens was accompanied by the increasing pool of these elements in the organisms at the end of the experiment. Copper was accumulated throughout the experiment in experimental group 1, compared to the reference, with the maximum difference in the liver of 36.5% ( ≤ 0.05), in the feathers 2.5 times ( ≤ 0.01). Assessment of the Zn level dynamics in the feathers revealed a well noticeable tendency to reducing its concentrations during the experiment in all groups. Against the background of feeding a nanoscale alloy, Zn concentration in the liver exceeded the reference by 66.8% ( ≤ 0.01) only at the end of the experiment. Thus, nanoscale forms of Cu and Zn have a cumulative effect, and may become an alternative to inorganic and organic forms of these elements in poultry nutrition.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7283368 | PMC |
http://dx.doi.org/10.1016/j.aninu.2019.11.007 | DOI Listing |
Nanoscale
January 2025
College of Materials Science and Engineering, Taiyuan University of Technology, Taiyuan, 030024, Shanxi, China.
Self-corrosion and low practical voltage of anodes severely limit the usage of Mg-air batteries. Although many elements, including indium (In), have been used to enhance the discharge characteristics of Mg anodes, unclear mechanism of the action of a single element and lack of research on binary alloys as anodes have restricted the development of Mg-air batteries. Herein, Mg-In ( = 0.
View Article and Find Full Text PDFSmall
January 2025
Institute for Ecological Research and Pollution Control of Plateau Lakes, School of Ecology and Environmental Science, Yunnan University, Kunming, Yunnan, 650504, China.
The design and fabrication of nanocatalysts with high accessibility and sintering resistance remain significant challenges in heterogeneous electrocatalysis. Herein, a novel catalyst is introduced that combines electronic pumping with alloy crystal facet engineering. At the nanoscale, the electronic pump leverages the chemical potential difference to drive electron migration from one region to another, separating and transferring electron-hole pairs.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China.
In this study, a novel Cu-bearing 304 stainless steel doped with 4.0 wt.% Cu (304-Cu SS) was developed, and the effects of nitrogen microalloying (304N-Cu SS) and heat treatment on mechanical, antibacterial, and corrosion properties were investigated.
View Article and Find Full Text PDFACS Nano
January 2025
Department of Materials Chemistry, National Institute of Chemistry, Hajdrihova 19, 1000 Ljubljana, Slovenia.
Nanoparticulate electrocatalysts for the oxygen reduction reaction are structurally diverse materials. Scanning transmission electron microscopy (STEM) has long been the go-to tool to obtain high-quality information about their nanoscale structure. More recently, its four-dimensional modality has emerged as a tool for a comprehensive crystal structure analysis using large data sets of diffraction patterns.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China.
High-entropy alloys (HEAs) with ultrafine grained and high strength can be prepared by mechanical alloying (MA) followed by sintering. Therefore, MA, as a unique solid powder processing method, has many effects on the microstructures and mechanical properties of the sintered bulk HEAs. This work focused on the alloying behavior, morphology, and phase evolution of FeCrNiAl (x = 1.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!