The SiO-based composites containing different carbon structures were prepared from asphalt and graphite by the milling, spray drying, and pyrolysis. In the obtained near-spherical composite particles, the refined amorphous SiO plates, which are coated with an amorphous carbon layer, are aggregated with the binding of graphite sheets. The SiO/C/Graphite composites present a maximum initial charge capacity of 963 mAh g at 100 mA g, excellent cyclic stability (~950 mAh g over 100 cycles), and rate capability with the charge capacity of 670 mAh g at 1,000 mA g. This significant improvement of electrochemical performances in comparison with pristine SiO or SiO/C composite is attributed to the unique microstructure, in which both the graphite sheets and amorphous carbon coating could enhance the conductivity of SiO and buffer the volume change of SiO. The higher pyrolysis temperature causes the denser spherical microstructure and better cycle life. Our work demonstrates the potential of this SiO/C/Graphite composite for high capacity anode of LIBs.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7243856 | PMC |
| http://dx.doi.org/10.3389/fchem.2020.00388 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Sustainable CO Capture: N,S-Codoped Porous Carbons Derived from Petroleum Coke with High Selectivity and Stability.
Molecules
January 2025
Key Laboratory of the Ministry of Education for Advanced Catalysis Materials, Zhejiang Normal University, Jinhua 321004, China.
CO capture from the flue gas is a promising approach to mitigate global warming. However, regulating the carbon-based adsorbent in terms of textural and surface modification is still a challenge. To overcome this issue, the present study depicts the development of cost-effective and high-performance CO adsorbents derived from petroleum coke, an industrial by-product, using a two-step process involving thiourea modification and KOH activation.
View Article and Find Full Text PDFPartially amorphous vanadium oxysulfide for achieving high-performance Li-ion batteries.
J Colloid Interface Sci
January 2025
College of Materials Science and Engineering, Nanjing Tech University, Nanjing 211816 China. Electronic address:
Vanadium-based materials exhibit a high theoretical capacity and diverse valence states, rendering them promising candidate anodes for lithium-ion batteries (LIBs). However, the cycling and rate performance are limited by their weak structural stability and electrical conductivity. Herein, a rational amorphization strategy has been developed to construct dual-anion vanadium oxysulfide nanoflowers (VSO NFs) with partial amorphous components and abundant oxygen vacancies as anode material for LIBs.
View Article and Find Full Text PDFChitosan-Based Porous Carbon Materials with Built-In Lewis Acid Boron Sites for Enhanced CO Capture and Conversion via an Electron-Inducing Effect.
ACS Appl Mater Interfaces
January 2025
Key Laboratory of Green Chemical and Clean Energy Technology, School of Chemistry and Chemical Engineering, Guizhou University, Guiyang 550025, P. R. China.
Electron-induced effects, which are prevalent in adsorption and heterogeneous catalytic reactions, can significantly influence the state and uptake of adsorbates. Here, we demonstrate the in situ doping of electron-deficient boron into the backbone of chitosan-based porous carbon materials. Despite a reduction in specific surface area, the resulting boron-doped porous carbons (NBPCs) exhibit an enhanced CO adsorption performance, with sample NBPC-10 achieving CO adsorption capacities of 7.
View Article and Find Full Text PDF-β, β-β' trifused porphyrins: synthesis, spectral, electrochemical and DFT studies and their femtosecond third-order nonlinear optical properties.
Dalton Trans
January 2025
Department of Chemistry, Indian Institute of Technology Roorkee, Roorkee, 247667, India.
-β, β-β' trifused porphyrins incorporating two distinct active methylene groups (MN = malononitrile and IND = 1,3-indanedione) and their corresponding metal complexes with Cu(II) and Zn(II) have been synthesized with good to excellent yields and characterized by various spectroscopic techniques and spectrometric methods. Single crystal X-ray analysis of the Zn(II) complex ZnTFPMB(MN) (where TFP = trifused porphyrin and MB = mono benzo) revealed a nonplanar 'armchair' type conformation with a twist angle of 24.10°.
View Article and Find Full Text PDFSodium-Rich Prussian Blue Analogs Synthesized with Reducing Sodium Salt for Enhanced Rate and Cycling Stability Sodium-Ion Storage.
ACS Appl Mater Interfaces
January 2025
Advanced Battery Technology Center, Harbin Institute of Technology, Weihai 264209, China.
Prussian blue analogs (PBAs) as cathode material for sodium-ion batteries have attracted widespread attention due to their affordability, simple synthesis, and high theoretical capacity. Nevertheless, the oxidation of Fe and sodium loss lead to poor electrochemical properties which restrict the practical use of PBAs. Herein, a simple coprecipitation approach based on sodium salt-reduction-assisted synthesis was proposed to construct high-sodium PBAs.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!