A thermal-sensitive "jelly" was used to control the diffusion of a diamine monomer for synthesizing polyamide free-standing nanofilms with an adjustable thickness of 5-35 nm. The reduced reaction rate of the interfacial polymerization at the hexane-"jelly" interface made the synthesized nanofilms show high water permeation flux and suitable salt rejection, and they also have highly negative surface charges and fairly smooth surfaces.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/d0cc02555k | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Lignin alkali regulated interfacial polymerization towards ultra-selective and highly permeable nanofiltration membrane.
Nat Commun
January 2025
School of Environmental Science and Engineering, Sun Yat-sen University, Guangzhou, China.
Thin-film composite polyamide (TFC PA) membranes hold promise for energy-efficient liquid separation, but achieving high permeance and precise separation membrane via a facile approach that is compatible with present manufacturing line remains a great challenge. Herein, we demonstrate the use of lignin alkali (LA) derived from waste of paper pulp as an aqueous phase additive to regulate interfacial polymerization (IP) process for achieving high performance nanofiltration (NF) membrane. Various characterizations and molecular dynamics simulations revealed that LA can promote the diffusion and partition of aqueous phase monomer piperazine (PIP) molecules into organic phase and their uniform dispersion on substrate, accelerating the IP reaction and promoting greater interfacial instabilities, thus endowing formation of TFC NF membrane with an ultrathin, highly cross-linked, and crumpled PA layer.
View Article and Find Full Text PDFHigh-Rate 4.2 V Solid-State Potassium Batteries by In Situ Polymerized Epoxide Ether Electrolyte.
Nano Lett
January 2025
College of Materials Science and Engineering, Hunan Joint International Laboratory of Advanced Materials and Technology of Clean Energy, Hunan Province Key Laboratory for Advanced Carbon Materials and Applied Technology, Hunan University, Changsha 410082, China.
Article Synopsis
- Solid-state metallic potassium batteries (SSMPBs) are gaining attention as alternatives to lithium batteries, but face challenges like low ionic conductivity and high interfacial resistance.
- Researchers achieved improved performance by using in situ ring-opening polymerization with a plasticizer and catalyst, resulting in short-chain polyether electrolytes that significantly enhance ionic conductivity.
- The developed SSMPBs show a high discharge capacity of 69 mAh/g at 100 mA/g and 88.8% capacity retention after 100 cycles, outperforming previous SSMPB studies.
Hierarchical-Porous Hollow Nitrogen-Doped Carbon-Supported Pt Alloy Catalysts with a Controllable Triheterointerface for Methanol Electrooxidation.
ACS Appl Mater Interfaces
January 2025
School of Chemistry and Chemical Engineering, Beijing Institute of Technology, Beijing 100081, China.
Carbon-supported Pt-based catalysts are the most effective catalysts for direct methanol fuel cells (DMFCs). However, challenges such as high Pt loading, cost, and susceptibility to CO poisoning severely hinder the development of DMFCs. In this paper, CoFeO@polymer@ZIF-67 is prepared successfully through sequential solution polymerization and in situ growth with modified CoFeO as the core.
View Article and Find Full Text PDFGeneral synthesis of neighboring dual-atomic sites with a specific pre-designed distance via an interfacial-fixing strategy.
Nat Commun
January 2025
Anhui University of Technology, Ma'anshan, Anhui, 243002, P. R. China.
A potential non-precious metal catalyst for oxygen reduction reaction should contain metal-N moieties. However, most of the current strategies to regulate the distances between neighboring metal sites are not pre-designed but depend on the probability by tuning the metal loading or the support. Herein, we report a general method for the synthesis of neighboring metal-N moieties (metal = Fe, Cu, Co, Ni, Zn, and Mn) via an interfacial-fixing strategy.
View Article and Find Full Text PDFRecent perspective of synthesis and modification strategies of cellulose nanocrystals and cellulose nanofibrils and their beneficial impact in scaffold-based tissue engineering: A review.
Int J Biol Macromol
December 2024
Department of Chemistry, College of Sciences, Shiraz University, Shiraz, Iran. Electronic address:
Outstanding properties of nanocellulose provide opportunities for novel applications in various fields, particularly tissue engineering. Despite of numerous useful characteristics of nanocellulose, its production methods suffer from the lack of control of morphology, high cost, and the use of organic solvents. On the other hand, hydrophilicity of nanocellulose is a significant challenge for its dispersion as a reinforcement in hydrophobic polymers matrix.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!