In the present report, thermally stimulated luminescence (TSL) of quartz and limestone samples irradiated with β and γ-rays has been investigated. Herein the formation of trap depths and calculation of kinetic parameters of β and γ - irradiated quartz and limestone samples were studied through thermoluminescence (TL) glow curve analyses. The quartz and limestone samples were collected from various sites of Chhattisgarh (Patharia and Dalli-Rajhara mines). The collected raw samples were annealed at 400 °C. The phase formation of collected samples is confirmed by X-ray diffraction studies. The grain sizes of the samples are determined by using Debye-Scherrer formula. TL glow curves of the collected samples were recorded for various doses of β and γ-rays. Kinetic parameters such as order of kinetics frequency factor and trap depth were calculated by employing CGCD methods. A comparative study on the TL properties of the geological materials under β and γ-irradiation was done. The trap model analysis was executed to determine the nature of traps responsible for dominant TL peaks of β and γ-irradiated limestone and quartz samples.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s10895-020-02536-9DOI Listing

Publication Analysis

Top Keywords

quartz limestone
12
limestone samples
12
geological materials
8
samples
8
kinetic parameters
8
collected samples
8
thermoluminescence studies
4
studies γ-irradiated
4
γ-irradiated geological
4
materials environment
4

Similar Publications

The impact of coarse aggregate mineral compositions on skid resistance performance of asphalt pavement: A comprehensive study.

PLoS One

December 2024

Key Laboratory of Intelligent Construction and Maintenance of CAAC, Xi'an, Shaanxi, China.

This study aimed to investigate the influence of different coarse aggregate mineral compositions on the skid resistance performance of asphalt pavement. The imprint method was utilized to assess the contact probability between various graded asphalt surface aggregates and tires. Additionally, macroscopic adhesive friction coefficients between polished surfaces of three types of rock slabs (basalt, limestone, granite) and rubber were determined using a pendulum friction tester.

View Article and Find Full Text PDF

Impact of microbial activity on fluoride release from sediments in areas with high fluoride groundwater: Mechanisms, sources and the lithology diversity.

Sci Total Environ

December 2024

State Key Laboratory of Biogeology and Environmental Geology and School of Environmental Studies, China University of Geosciences, 430074 Wuhan, Hubei, China.

This study explores the interplay between microbial activity and sediment lithology in influencing fluoride release from sediments. Sediment samples, collected from Yuncheng Basin: a region known for significant groundwater fluoride contamination, exhibit fluoride concentrations well above the global average, ranging from 206.2 mg/kg to 780.

View Article and Find Full Text PDF

Mineral composition, pore structure and mechanical properties of coal measure strata rocks: A case study of Pingdingshan Coalfield.

Sci Total Environ

November 2024

State Key Laboratory of Coal Mine Disaster Dynamics and Control, Chongqing University, Chongqing 400044, China; School of Resources and Safety Engineering, Chongqing University, Chongqing 400044, China.

The microstructure and mechanical properties of coal measure rocks (CMR) are critical factors in the successful geological storage of CO. While previous research has predominantly focused on coal seams, the overlying and underlying bedrock strata are equally significant yet often overlooked. This study addresses this gap by selecting coal and adjacent strata from the Twelve Mine as representative samples.

View Article and Find Full Text PDF

Influence of Mineral Additives on Strength Properties of Standard Mortar.

Materials (Basel)

August 2024

Faculty of Civil Engineering and Geodesy, Military University of Technology, 2 Gen. Sylwestra Kaliskiego Str., 00-908 Warsaw, Poland.

In the article, the authors presented the results of research on the assessment of the effect of selected mineral additives on the strength properties of the standard mortar. The modification of the composition of the standard mortar made on the basis of CEM I 42.5R cement and quartz sand consisted of using seven selected mineral additives in the form of compacted microsilica, Mikrosill microsilica, limestone flour, glass flour, glass granulate, basalt flour, and fly ash in the amounts of 10 and 20% in relation to cement as its substitute.

View Article and Find Full Text PDF

Mix and measure II: joint high-energy laboratory powder diffraction and microtomography for cement hydration studies.

J Appl Crystallogr

August 2024

Departamento de Química Inorgánica, Cristalografía y Mineralogía Universidad de Málaga 29071Málaga Spain.

Portland cements (PCs) and cement blends are multiphase materials of different fineness, and quantitatively analysing their hydration pathways is very challenging. The dissolution (hydration) of the initial crystalline and amorphous phases must be determined, as well as the formation of labile (such as ettringite), reactive (such as portlandite) and amorphous (such as calcium silicate hydrate gel) components. The microstructural changes with hydration time must also be mapped out.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!