Hierarchically three dimensional (3D) flower-like magnesium peroxide (MgO) nanostructures were synthesized through a facile one-step precipitation method. The effects of magnesium salt, reaction temperature, precipitant and surfactant on the morphology and structure of MgO were systematically investigated. The as-obtained samples using magnesium sulfate, ammonia and trisodium citrate were composed of 3D flowers assembled by numerous nanosheets, and SO played a vital role in the formation of flower-like nanostructures. The 3D flower-like MgO possessed high active oxygen content of 24.10 wt% and large specific surface area of 385 m/g. Ten mg of flower-like MgO could efficiently degrade 90 % of tetracycline (TC) within 60 min under stirring condition. ESR tests and radical quenching experiments suggested that hydroxyl radicals were crucial for TC degradation. Moreover, the column filled with flower-like MgO could quickly and efficiently eliminate TC with the assistance of air flow, and the degradation efficiency almost had no decrease even after twenty consecutive runs. Significantly, the concentrations of magnesium and iron ions dissolved in the filtrate from the column were far below the limits of drinking water standards. Additionally, the possible degradation pathways of TC were also proposed according to the determination of generated intermediates during the degradation process.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jhazmat.2020.122877DOI Listing

Publication Analysis

Top Keywords

flower-like mgo
12
facile one-step
8
flower-like magnesium
8
magnesium peroxide
8
mgo efficiently
8
flower-like
6
magnesium
5
mgo
5
one-step synthesis
4
synthesis hierarchical
4

Similar Publications

Electrochemical signal amplification strategy based on trace metal ion modified WS for ultra-sensitive detection of miRNA-21.

Talanta

August 2023

Hubei Province Key Laboratory of Occupational Hazard Identification and Control, School of Medicine, School of Public Health, Wuhan University of Science and Technology, Wuhan, 430065, PR China. Electronic address:

Previous researches have suggested the potential correlation between the development of breast cancer and the concentration of miRNA-21 in serum. Theoretically the doping of multivalent metal ions in WS could bring higher electron transfer capacity, but this hasn't been proven. To fill this research gap, through one-pot method we prepared seven nanocomposite structures modified with different metal ions (Co, Ni, Mn, Zn, Fe, Cr, La).

View Article and Find Full Text PDF

Sustainable chemistry research prioritizes reducing atmospheric carbon dioxide, and one logical solution is to develop adsorbents suitable for carbon capture and utilization. In this work, a new family of three-dimensional (3D) flower-like Mn-promoted MgO was synthesized by the coprecipitation method and used as an adsorbent for CO capture and a catalyst for CO utilization. The scanning electron microscopy (SEM) analysis of the samples shows a 3D architecture composed of thin nanosheets.

View Article and Find Full Text PDF

Magnesium lignosulfonate-derived N, S co-doped 3D flower-like hierarchically porous carbon as an advanced metal-free electrocatalyst towards oxygen reduction reaction.

Int J Biol Macromol

June 2022

Liaoning Key Laboratory of Lignocellulosic Chemistry and Biomaterials, College of Light Industry and Chemical Engineering, Dalian Polytechnic University, Dalian, Liaoning 116034, China.

The development of metal-free electrocatalytic materials that are economical, friendly to the environment, and efficiency towards the oxygen reduction reaction (ORR) is of significant interest. Hence, this paper synthesizes nitrogen and sulfur co-doped three-dimensional magnesium lignosulfonate (MLS-derived) flower-like hierarchical porous carbon (NSLPC) materials by a simple and green method. The synthesized NSLPC uses magnesium lignosulfonate as the sulfur source and carbon precursor, melamine as nitrogen source, MgO as hard template, and ZnCl as the activator.

View Article and Find Full Text PDF

Insight into the role and mechanism of polysaccharide in polymorphous magnesium oxide nanoparticle synthesis for arsenate removal.

Chemosphere

June 2022

Key Laboratory of Catalysis Conversion and Energy Materials, Ministry of Education, South-Central University for Nationalities, Wuhan, 430074, China; Engineering Research Center for Heavy Metal Pollution Control of Hubei Province, College of Resources and Environmental Science, South-Central University for Nationalities, Wuhan, 430074, China. Electronic address:

The low cost and non-toxic of magnesium oxides make it a potential eco-friendly material for arsenic removal. Polysaccharide is a kind of green modifier to obtain nanoscale MgO particles with a higher adsorption affinity. In this study, the impact of chain structures of polysaccharides on the morphology features and arsenate removal efficiency of MgO-NPs were investigated.

View Article and Find Full Text PDF

The absorption of CO on MgO is being studied in depth in order to enhance carbon engineering. Production of carbonate on MgO surfaces, such as MgCO, for example, has been shown to hinder further carbon lattice transit and lower CO collecting efficiency. To avoid the carbonate blocking effect, we mimic the water harvesting nano-surface systems of desert beetles, which use alternate hydrophobic and hydrophilic surface domains to collect liquid water and convey condensed droplets down to their mouths, respectively.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!