A new, efficient method for analysis of organic micropollutants (OMPs) in water samples was developed, validated and applied in a nationwide survey. The goal with the survey was to identify common compounds with relatively high concentrations to be used as markers e.g. for routine monitoring of removal efficiencies. The method comprises sample concentration by evaporation, and large volume injection on a standard UHPLC-MS/MS system. The OMPs selected for this approach were mainly semi-polar and non-volatile, with molecular weights below 300 Da. Except one outlier, the limit of detection (LoD) ranged from 0.01 to 1 ng/L which is sufficient for most surface waters, and also useful for many ground waters. The method requires low manual labor and comparably small sample volumes, enabling a cost-efficient nationwide screening. Raw- and drinking water from 90 Swedish water treatment plants (WTPs) were investigated for occurrence of the selected OMPs. Carbamazepine and tramadol were the most widespread compounds, detected in around 50% of the surface waters. Ground water from rock aquifers were least contaminated, while soil aquifers were more similar to surface waters. Due to the frequent use of ground water in Sweden, many samples did not contain any of the investigated compounds (i.e. below LoD). In the positive samples, the median estimated concentrations of individual OMPs were generally <1 ng/L in raw water and <0.5 ng/L in drinking water. Swedish waters were in general less contaminated than those investigated in similar Brazilian, Chinese, pan-European and US studies. Altogether, the presented methodology gave a cost-efficient overview on the occurrence and estimated concentrations of OMPs in raw- and drinking water on a national level in Sweden. From the data, WTPs can find suitable OMPs to monitor at their site, for example for measuring removal efficiencies on a routine basis.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.scitotenv.2020.138069 | DOI Listing |
Environ Sci Pollut Res Int
December 2024
Stazione Sperimentale Per L'industria Delle Pelli E Delle Materie Concianti S.R.L., 80143, Napoli, Italy.
Leather manufacturing is the process of converting raw animal hides or skins into finished leather. The complex industrial procedures result in a tanning effluent composed of chemical compounds with potentially hazardous impacts on humans and ecosystems. Among the traditional and efficient wastewater treatments, adsorption is an effective and well-known approach, able to manage a wide range of contaminants from wastewater.
View Article and Find Full Text PDFLangmuir
December 2024
Department of Physical Chemistry, Faculty of Chemistry and Petroleum Sciences, Bu-Ali Sina University, Hamedan 65167 ,Iran.
Interfacial solar evaporator generation (ISVG) is a new, cost-effective, and eco-friendly emerging method for water desalination. Two main criteria for evaluating ISVG performance are evaporation rate () and solar-to-vapor conversion efficiency (η). The main challenge of the previously presented models for the estimation of and η in 2D systems is that in most cases the calculated values are beyond the theoretical limits, > 1.
View Article and Find Full Text PDFPlant Signal Behav
December 2025
State Key Laboratory of Herbage Improvement and Grassland Agro-Ecosystems, College of Ecology, Lanzhou University, Lanzhou, Gansu, China.
Abscisic acid (ABA) mediated stomatal closure is a highly effective mode of active stomatal regulation under drought stress. Previous studies on stomatal regulation have primarily focused on the leaves of vascular plants, while research on the stomatal behavior of bulbous plants remains unknown. In addition, ABA-induced stomatal regulation in bulbs has yet to be explored.
View Article and Find Full Text PDFACS Appl Mater Interfaces
December 2024
Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, No. 2, Nengyuan Rd., Tianhe DistrictGuangzhou 510640, China.
MCM-41, a mesoporous material with a high surface area and tunable pore size, shows great potential for water vapor adsorption. However, due to its large pore size, the effective adsorption capacity at medium to low relative partial pressures is limited in adsorption chiller applications. In this work, MCM-41 was successfully synthesized at room temperature using cetyltrimethylammonium bromide (CTAB) as a templating agent.
View Article and Find Full Text PDFEnviron Sci Pollut Res Int
December 2024
Department of Chemistry and Biology "Adolfo Zambelli", University of Salerno, Via Giovanni Paolo II, 132, 84084, Fisciano, SA, Italy.
Anthropogenic pressures affect large stretches of Mediterranean coastal environments, determining alterations, including chemical pollution, able to impair ecosystem functioning and services. Among the pollutants of major concern for their toxicity and persistence, there are polycyclic aromatic hydrocarbons (PAHs), which can be effectively monitored through bioaccumulation approaches. However, the main biomonitor of PAHs in the Mediterranean Sea, Posidonia oceanica, is currently undergoing extensive regressions due to anthropogenic pressures, forcing the search for alternative biomonitors.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!