Radioactive particles originating from nuclear fuel reprocessing at the United Kingdom Atomic Energy Authority's Dounreay Facility were inadvertently released to the environment in the late 1950s to 1970s and have subsequently been found on site grounds and local beaches. Previous assessments of risk associated with encountering a particle have been based on conservative assumptions related to particle composition and speciation. To reduce uncertainties associated with environmental impact assessments from Dounreay particles, further characterization is relevant. Results of particles available for this study showed variation between Dounreay Fast Reactor (DFR) and Materials Test Reactor (MTR) particles, reflecting differences in fuel design, release scenarios, and subsequent environmental influence. Analyses of DFR particles showed they are small (100-300 μm) and contain spatially correlated U and Nb. Molybdenum, part of the DFR fuel, was identified at atomic concentrations below 1%. Based on SR-based micrometer-scale X-ray Absorption Near Edge Structure spectroscopy (μ-XANES), U may be present as U(IV), and, based on a measured Nb/U atom ratio of ~2, stoichiometric considerations are commensurable with the presence of UNbO. The MTR particles were larger (740-2000 μm) and contained U and Al inhomogeneously distributed. Neodymium (Nd) was identified in atomic concentrations of around 1-2%, suggesting it was part of the fuel design. The presence of U(IV) in MTR particles, as indicated by μ-XANES analysis, may be related to oxidation of particle surfaces, as could be expected due to corrosion of UAl fuel particles in air. High U/U atom ratios in individual DFR (3.2 ± 0.8) and MTR (2.6 ± 0.4) particles reflected the presence of highly enriched uranium. The DFR particles featured lower Cs activity levels (2.00-9.58 kBq/particle) than the MTR (43.2-641 kBq Cs/particle) particles. The activities of the dose contributing radionuclides Sr/Y were proportional to Cs (Sr/Cs activity ratio ≈ 0.8) and particle activities were roughly proportional to the size. Based on direct beta measurements, gamma spectrometry, and the VARSKIN6 model, contact dose rates were calculated to be approximately 74 mGy/h for the highest activity MTR particle, in agreement with previously published estimates.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.scitotenv.2020.138488 | DOI Listing |
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!