Arrays of nanoelectromechanical resonators (NEMS) have shown promise for a suite of applications, from nanomechanical information processing technologies to mass spectrometry. A fundamental challenge toward broader adoption of NEMS arrays is a lack of viable frequency tuning methods, which must simultaneously allow for persistent and reversible control of single resonators while also being scalable to large arrays of devices. In this work, we demonstrate an electro-optic tuning method for graphene-based NEMS where locally photoionized charge tensions a suspended membrane and tunes its resonance frequency. The tuned frequency state persists unchanged for several days in the absence of any external power, and the state can be repeatedly written and erased with a high degree of precision. We show the scalability of this technique by aligning the frequencies of several NEMS devices on the same chip, and we discuss implications of this tuning method for both single devices and programmable NEMS networks.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.nanolett.9b05003DOI Listing

Publication Analysis

Top Keywords

frequency tuning
8
tuning method
8
nems
5
nonvolatile rewritable
4
frequency
4
rewritable frequency
4
tuning
4
tuning nanoelectromechanical
4
nanoelectromechanical resonator
4
resonator photoinduced
4

Similar Publications

A Review of Miniature Radio Transmitters for Wildlife Tracking.

Sensors (Basel)

January 2025

The Blavatnik School of Computer Science and AI, Tel Aviv University, Tel Aviv 69978, Israel.

This article surveys the literature on miniature radio transmitters designed to track free-ranging wild animals using emitter-localization techniques. The articles covers the topics of power sources used in such transmitters, including miniature batteries and energy harvesting, techniques for generating the transmitted radio-frequency carrier, techniques for creating short radio pulses and more general on-off schedules, modulation in modern wildlife-tracking transmitters, construction, manufacturing, and tuning techniques, and recent trends in this area. The article also describes the recreation of the first successful wildlife-tracking transmitter, a nontrivial invention that had a profound impact on wildlife ecology, and explores its behavior.

View Article and Find Full Text PDF

A Reading Range- and Frequency-Reconfigurable Antenna for Near-Field and Far-Field UHF RFID Applications.

Sensors (Basel)

January 2025

Department of Electrical and Electronic Engineering, The University of Manchester, Manchester M13 9PL, UK.

In radio frequency identification (RFID), differences in spectrum policies and tag misreading in different countries are the two main issues that limit its application. To solve these problems, this article proposes a composite right/left-handed transmission line (CRLH-TL)-based reconfigurable antenna for ultra-high frequency near-field and far-field RFID reader applications. The CRLH-TL is achieved using a periodically capacitive gap-loaded parallel plate line.

View Article and Find Full Text PDF

This paper presents the design and performance evaluation of an inductive conductivity sensor with a double tuning impedance matching network to enhance sensitivity and improve linearity. The sensor's equivalent circuit model is analyzed and verified through simulation, and impedance matching is shown to significantly increase the sensor's output signal, particularly at low conductivity measurements. Double tuning impedance matching expands the frequency response range and optimizes power transfer efficiency, achieving a higher power factor across a broader frequency range.

View Article and Find Full Text PDF

This paper focuses on the theoretical and analytical modeling of a novel seismic isolator termed the Passive Friction Mechanical Metamaterial Seismic Isolator (PFSMBI) system, which is designed for seismic hazard mitigation in multi-story buildings. The PFSMBI system consists of a lattice structure composed of a series of identical small cells interconnected by layers made of viscoelastic materials. The main function of the lattice is to shift the fundamental natural frequency of the building away from the dominant frequency of earthquake excitations by creating low-frequency bandgaps (FBGs) below 20 Hz.

View Article and Find Full Text PDF

Tunable Filters Using Defected Ground Structures at Millimeter-Wave Frequencies.

Micromachines (Basel)

December 2024

Center of Excellence for Thin-Film Research and Surface Engineering (CETRASE), Department of Electrical and Computer Engineering, University of Dayton, Dayton, OH 45469, USA.

This paper explores the potential of phase change materials (PCM) for dynamically tuning the frequency response of a dumbbell u-slot defected ground structure (DGS)-based band stop filter. The DGSs are designed using co-planar waveguide (CPW) line structure on top of a barium strontium titanate (BaSrTiO) (BST) thin film. BST film is used as the high-dielectric material for the planar DGS.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!