Ocular exposure to metal oxide engineered nanomaterials (ENMs) is common as exemplified by zinc oxide (ZnO), a major constituent of sunscreens and cosmetics. The ocular surface that includes the transparent cornea and its protective tear film are common sites of exposure for metal ENMs. Despite the frequency of exposure of the ocular surface, there is a knowledge gap regarding the effects of metal oxide ENMs on the cornea in health and disease. Therefore, we studied the effects of metal oxide ENMs on the cornea in the presence or absence of injury. Cell viability of immortalized human corneal epithelial (hTCEpi) cells was assessed following treatment with 11 metal oxide ENMs with a concentration ranging from 0.5 to 250 μg/mL for 24 hours. An epithelial wound healing assay with a monolayer of hTCEpi cells was then performed using 11 metal oxide ENMs at select concentrations based on data from the viability assays. Subsequently, based on the results, testing of precorneal tear film (PTF) quantity and stability as well as a corneal epithelial wound healing were tested in the presence or absence ZnO or vanadium pentoxide (VO) at a concentration of 50 μg/mL. We found that WO, ZnO, VO and CuO ENMs significantly reduced hTCEpi cell viability in comparison to vehicle control or the other metal oxide ENMs tested. Furthermore, ZnO and VO ENMs also significantly decreased hTCEpi cell migration. Although ZnO and VO did not alter PTF parameters of rabbits , corneal epithelial wound healing was significantly delayed by topical ZnO while VO did not alter wound healing. Finally, hyperspectral images confirmed penetration of ZnO and VO through all corneal layers and into the iris stroma. Considering the marked epithelial toxicity and corneal penetration of ZnO, further investigations on the impact of this ENM on the eye are warranted.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7062360PMC
http://dx.doi.org/10.1016/j.impact.2019.100198DOI Listing

Publication Analysis

Top Keywords

metal oxide
28
wound healing
20
oxide enms
20
corneal epithelial
16
epithelial wound
16
enms
9
oxide
8
exposure metal
8
zno
8
ocular surface
8

Similar Publications

Solid-state nanopores offer unique possibilities for biomolecule sensing; however, scalable production of sub-5 nm pores with precise diameter control remains a manufacturing challenge. In this work, we developed a scalable method to fabricate sub-5 nm nanopores in silicon (Si) nanomembranes through metal-assisted chemical etching (MACE) using gold nanoparticles. Notably, we present a previously unreported self-limiting effect that enables sub-5 nm nanopore formation from both 10 and 40 nm nanoparticles in the 12 nm thick monocrystalline device layer of a silicon-on-insulator substrate.

View Article and Find Full Text PDF

Chemical etching of silicon assisted by graphene oxide under negative electric bias.

Nanoscale Adv

January 2025

Department of Materials Science and Engineering, Graduate School of Engineering, Kyoto University Yoshida-honmachi, Sakyo-ku Kyoto 606-8501 Japan

Chemical etching of silicon assisted by graphene oxide (GO) has been attracting attention as a new method to fabricate micro- or nano-structures. GO promotes the reduction of an oxidant, and holes are injected into silicon, resulting in the preferential dissolution of the silicon under GO. In the conventional etching method with GO, the selectivity of the etching was low due to the stain etching caused by nitric acid.

View Article and Find Full Text PDF

Nickel alloys are widely used in the oil and gas industry where high corrosion resistance in chloride water or in sour environments is required. When high mechanical properties are required in combination with high corrosion properties, alloy 718 (UNS N07718) is one of the preferred choices, although it still presents limitations in terms of corrosion resistance in some applications: despite offering outstanding resistance to localized corrosion, alloy 718 is not immune to it. Its high corrosion resistance is mainly due to its high nickel and chromium contents combined with additions of molybdenum and other noble elements.

View Article and Find Full Text PDF

Methane (CH), which is the main component of natural gas, is an abundant and widely available carbon resource. However, CH has a low energy density of only 36 kJ L under ambient conditions, which is significantly lower than that of gasoline (. 34 MJ L).

View Article and Find Full Text PDF

This study investigates the development and characterization of a novel composite material consisting of polyvinyl alcohol (PVA) integrated with (UG) and zinc oxide (ZnO) as fillers. The synergistic effects of UG and ZnO were investigated, focusing on their ability to enhance the film's properties. UV-vis spectrophotometry demonstrated that the composite film effectively blocked all UV (UV-A and UV-B) and blue light wavelengths.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!