Polarity is among the critical characteristics that could governs the functionality of piezoelectric materials. In this study, the polarity of aluminum nitride (AlN) thin films was inverted from Al-polar to N-polar by doping Si into AlN in the range of 1-15 at.%. Polarity inversion from Al-polar to N-polar also occurred when MgSi was codoped into AlN with Mg to Si ratio was less than 1. However, the polarity can be reversed from N-polar to Al-polar when the ratio of Mg and Si was greater than 1. The effect of Si and MgSi addition was investigated with regards to their crystal structure, lattice parameters, polarity distribution and the oxidation state of each elements. Furthermore, the effect of intermediate layer as well as the presence of point defect (i.e. aluminum vacancy) were investigated and how these factors influence the polarity of the thin films are discussed in this report.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7062775 | PMC |
| http://dx.doi.org/10.1038/s41598-020-61285-8 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Mechanisms of the Photomechanical Response in Thin-Film Dye-Doped Glassy Polymers.
Polymers (Basel)
January 2025
Department of Physics, Washington State University, Pullman, WA 99163, USA.
This work aims to determine the mechanism of the photomechanical response of poly(Methyl methacrylate) polymer doped with the photo-isomerizable dye Disperse Red 1 using the non-isomerizable dye Disperse Orange 11 as a control to isolate photoisomerization. Samples are free-standing thin films with thickness that is small compared with the optical skin depth to assure uniform illumination and photomechanical response throughout their volume, which differentiates these studies from most others. Polarization-dependent measurements of the photomechanical stress response are used to deconvolute the contributions of angular hole burning, molecular reorientation and photothermal heating.
View Article and Find Full Text PDFEffect of the Current-Collecting Carbon Nanotubes Layer on the Properties of the Lead Zirconate Titanate Film for Vibration Sensors.
Sensors (Basel)
January 2025
Institute of Nanotechnologies, Electronics and Equipment Engineering, Southern Federal University, 347922 Taganrog, Russia.
One of the challenging problems in the research and development of vibration sensors relates to the formation of Ohmic contacts for the removal of an electrical signal. In some cases, it is proposed to use arrays of carbon nanotubes (CNTs), which can serve as highly elastic electrode materials for vibration sensors. The purpose of this work is to study the effect of a current-collecting layer of CNTs grown over silicon on the properties of a lead zirconate titanate (PZT) film, which is frequently employed in mechanical vibration sensors or energy harvesters.
View Article and Find Full Text PDFTuning Electrical Conductivity and Ultrafast Optical Nonlinearity of Reduced-GO Films Ablated by Femtosecond Laser Direct Writing.
Molecules
January 2025
Information Materials and Intelligent Sensing Laboratory of Anhui Province, Anhui University, Hefei 230601, China.
Carbon-based nanomaterials with excellent electrical and optical properties are highly sought after for a plethora of hybrid applications, ranging from advanced sustainable energy storage devices to opto-electronic components. In this contribution, we examine in detail the dependence of electrical conductivity and the ultrafast optical nonlinearity of graphene oxide (GO) films on their degrees of reduction, as well as the link between the two properties. The GO films were first synthesized through the vacuum filtration method and then reduced partially and controllably by way of femtosecond laser direct writing with varying power doses.
View Article and Find Full Text PDFFilms Based on Chitosan/Konjac Glucomannan Blend Containing Resveratrol for Potential Skin Application.
Materials (Basel)
January 2025
Department of Biomaterials and Cosmetic Chemistry, Faculty of Chemistry, Nicolaus Copernicus University in Torun, 7 Gagarin Street, 87-100 Torun, Poland.
Biopolymers represent a significant class of materials with potential applications in skin care due to their beneficial properties. Resveratrol is a natural substance that exhibits a range of biological activities, including the scavenging of free radicals and anti-inflammatory and anti-aging effects. In this study, chitosan/konjac glucomannan resveratrol-enriched thin films were prepared.
View Article and Find Full Text PDFResearch on the Aging Characteristics of Simulated Asphalt Within Pavement Structures in Natural Environments.
Materials (Basel)
January 2025
College of Civil Engineering, Nanjing Forestry University, Nanjing 210037, China.
The global asphalt production growth rate exceeded 10% in the past decade, and over 90% of the world's road surfaces are generated from asphalt materials. Therefore, the issue of asphalt aging has been widely researched. In this study, the aging of asphalt thin films under various natural conditions was studied to prevent the distortion of indoor simulated aging and to prevent the extraction of asphalt samples from road surfaces from impacting the aged asphalt.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!