In this paper, the seismic assessments of two footbridges, i.e., a single-span steel frame footbridge and a three-span cable-stayed structure, to the spatial variation of earthquake ground motion (SVEGM) are presented. A model of nonuniform kinematic excitation was used for the dynamic analyses of the footbridges. The influence of SVEGM on the dynamic performance of structures was assessed on both experimental and numerical ways. The comprehensive tests were planned and carried out on both structures. The investigation was divided into two parts: in situ experiment and numerical analyses. The first experimental part served for the validation of both the finite element (FE) modal models of structures and the theoretical model of nonuniform excitation as well as the appropriateness of the FE procedures used for dynamic analyses. First, the modal properties were validated. The differences between the numerical and the experimental natural frequencies, obtained using the operational modal analysis, were less than 10%. The comparison of the experimental and numerical mode shapes also proved a good agreement since the modal assurance criterion values were satisfactory for both structures. Secondly, nonuniform kinematic excitation was experimentally imposed using vibroseis tests. The apparent wave velocities, evaluated from the cross-correlation functions of the acceleration-time histories registered at two consecutive structures supports, equaled 203 and 214 m/s for both structures, respectively. Also, the coherence functions proved the similarity of the signals, especially for the frequency range 5 to 15 Hz. Then, artificial kinematic excitation was generated on the basis of the adopted model of nonuniform excitation. The obtained power spectral density functions of acceleration-time histories registered at all supports as well as the cross-spectral density functions between registered and artificial acceleration-time histories confirmed the strong similarity of the measured and artificial signals. Finally, the experimental and numerical assessments of the footbridges performance under the known dynamic excitation generated by the vibroseis were carried out. The FE models and procedures were positively validated by linking full-scale tests and numerical calculations. In the numerical part of the research, seismic analyses of the footbridges were conducted. The dynamic responses of structures to a representative seismic shock were calculated. Both the uniform and nonuniform models of excitation were applied to demonstrate and quantify the influence of SVEGM on the seismic assessment of footbridges. It occurred that SVEGM may generate non-conservative results in comparison with classic uniform seismic excitation. For the stiff steel frame footbridge the maximum dynamic response was obtained for the model of nonuniform excitation with the lowest wave velocity. Especially zones located closely to stiff frame nodes were significantly more disturbed. For the flexible cable-stayed footbridge, in case of nonuniform excitation, the dynamic response was enhanced only at the points located in the extreme spans and in the midspan closely to the pillars.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7070410PMC
http://dx.doi.org/10.3390/s20041227DOI Listing

Publication Analysis

Top Keywords

model nonuniform
16
nonuniform excitation
16
kinematic excitation
12
experimental numerical
12
acceleration-time histories
12
excitation
10
seismic assessment
8
assessment footbridges
8
spatial variation
8
variation earthquake
8

Similar Publications

The heating oil circuit plays an essential role in the heating calendering roller for the lithium battery pole piece. To achieve the optimization of the heating oil circuit, a fluid-thermal-structural coupling method and a multi-objective optimization procedure are proposed to obtain the optimal solution. A fluid-thermal-structural coupling flowchart based on the numerical modeling for the calendering roller temperature distribution is created to automate the analysis processes in the optimization iteration.

View Article and Find Full Text PDF

Synchronous vibrations, which are caused by periodic excitations, can have a severe impact on the service life of impellers. Blade Tip Timing (BTT) is a promising technique for monitoring synchronous vibrations due to its non-intrusive nature and ability to monitor all blades at once. BTT generally employs a Once-per-Revolution (OPR) sensor that is mounted on the shaft for blade identification and deflection calculation.

View Article and Find Full Text PDF

Alkali-silica reaction (ASR) is an important factor that seriously affects the durability of reinforced concrete (RC) structures. The current research on alkali-aggregate mainly focuses on the deterioration mechanism of materials and the mechanical properties of standard specimens. However, there is a gap in the field of research on the effect of alkali-aggregate damage on the level of RC structures.

View Article and Find Full Text PDF

Sandwich structures with triply periodic minimal surface (TPMS) cores have garnered research attention due to their potential to address challenges in lightweight solutions, high-strength designs, and energy absorption capabilities. This study focuses on performing finite element analyses (FEAs) on eight novel TPMS cores and one stochastic topology. It presents a method of analysis obtained through implicit modeling in simulations and examines whether the results obtained differ from a conventional method that uses a non-uniform rational B-spline (NURBS) approach.

View Article and Find Full Text PDF

A methodology is proposed, which addresses the caveat that line-of-sight emission spectroscopy presents in that it cannot provide spatially resolved temperature measurements in non-homogeneous temperature fields. The aim of this research is to explore the use of data-driven models in measuring temperature distributions in a spatially resolved manner using emission spectroscopy data. Two categories of data-driven methods are analyzed: (i) Feature engineering and classical machine learning algorithms, and (ii) end-to-end convolutional neural networks (CNN).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!