Production of bioethanol from unwashed-pretreated rapeseed straw at high solid loading.

Bioresour Technol

College of Architecture and Environment, Sichuan University, Chengdu 610065, China.

Published: May 2020

Reduction in water consumption and increase in ethanol concentration are two main challenges for bioethanol production from lignocellulosic materials. To address the two challenges, the aim of this work was to study the production of bioethanol from unwashed-pretreated rapeseed straw (RS) at high solid loading. RS pretreated with 1% (w w) HSO at 160 °C for 10 min resulted in excellent digestibility and fermentability of pretreated RS. The unwashed-pretreated RS was subjected to presaccharification and fed-batch simultaneous saccharification and fermentation (P-FB-SSF) at a final solid loading of 22% (w w). Ethanol concentration and ethanol yield of 53.1 g L (equivalent to 4.1% (w w) based on fermentation slurry) and 72.4% were obtained, respectively. In total, 92.1 g water g ethanol was consumed, a much smaller amount than that observed with washing after pretreatment or fermentation performed at lower solid loading.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biortech.2020.122949DOI Listing

Publication Analysis

Top Keywords

solid loading
16
production bioethanol
8
bioethanol unwashed-pretreated
8
unwashed-pretreated rapeseed
8
rapeseed straw
8
straw high
8
high solid
8
ethanol concentration
8
solid
4
loading
4

Similar Publications

Mechanically Robust Bismuth-Embedded Carbon Microspheres for Ultrafast Charging and Ultrastable Sodium-Ion Batteries.

J Am Chem Soc

January 2025

State Key Laboratory of Physical Chemistry of Solid Surfaces, College of Materials, Xiamen University, Xiamen 361005, China.

Advancements in the development of fast-charging and long-lasting microstructured alloying anodes with high volumetric capacities are essential for enhancing the operational efficiency of sodium-ion batteries (SIBs). These anodes, however, face challenges such as declined cyclability and rate capability, primarily due to mechanical degradation reduced by significant volumetric changes (over 252%) and slow kinetics of sodium-ion storage. Herein, we introduce a novel anode design featuring densely packed bismuth (Bi) embedded within highly conductive carbon microspheres to overcome the aforementioned challenges.

View Article and Find Full Text PDF

Energetic composite systems with uniform particle distributions are of considerable interest, but sedimentation is a persisting challenge. Tungsten carbide (WC, density: 15.36 g/cm) particles are promising cemented carbide particles owing to their desirable properties.

View Article and Find Full Text PDF

Introduction: Rhein, a natural bioactive lipophilic compound with numerous pharmacological activities, faces limitations in clinical application due to poor aqueous solubility and low bioavailability. Thus, this study aimed to develop a rhein-loaded self-nano emulsifying drug delivery system (RL-SNEDDS) to improve solubility and bioavailability.

Methods: The RL-SNEDDS was prepared by aqueous titration method with eucalyptus oil (oil phase), tween 80 (surfactant), and PEG 400 (co-surfactant) and optimization was performed by 3 factorial design.

View Article and Find Full Text PDF

Dielectric nanocomposites have garnered significant interest owing to their potential applications in energy storage. However, achieving high energy density (U) and charge/discharge efficiency (η) remains a challenge in their fabrication. In this paper, core-shell structured BaTiO@Polyvinylpyrrolidone (BT@PVP) nanoparticles are prepared, and incorporated into a semi-crystalline polyvinylidene fluoride (PVDF) matrix.

View Article and Find Full Text PDF

Screening of different lamellar solids for the adsorption of phenolic compounds from grape pomace.

Food Chem

December 2024

Section of Food, Biochemical, Physiological and Nutritional Sciences, Department of Pharmaceutical Sciences, University of Perugia, 06126 Perugia, Italy.

Grape pomace (GP) is recognized as a valuable source of polyphenols, prompting research into new therapeutic molecules while enhancing this by-product value. To address low stability and bioavailability issues of phenolic compounds, lamellar solids emerge as a promising approach for their loading and stabilization in food, cosmetic, and pharmaceutical applications. A solid phase adsorption procedure was developed here by comparing the properties of eight solids towards GP polyphenols.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!