The effect of cationic concentration on controlling the interlayer spacings of graphene oxide (GO) membranes is systemically studied. It was found that a higher concentration leads to narrower interlayer spacings, and thus, ions in salt solutions were effectively rejected. This provides a new avenue for ion separation using graphene-based membranes.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/c9cc08039b | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
synthesis of a UIO-66-NH@TiC composite for advanced electrochemical detection of acetaminophen.
Nanoscale
January 2025
Hubei Key Laboratory of Material Chemistry and Service Failure, Key Laboratory of Material Chemistry for Energy Conversion and Storage (Ministry of Education), Hubei Engineering Research Center for Biomaterials and Medical Protective Materials, School of Chemistry and Chemical Engineering, Huazhong University of Science and Technology, 1037 Luoyu Rd, Wuhan, China.
Acetaminophen (AP) is a widely used analgesic and antipyretic drug, but its excessive use poses health risks and contributes to environmental contamination. In response to the need for rapid, accurate, and cost-effective detection methods, we developed a highly sensitive and selective electrochemical sensor for AP. The sensor was based on a composite of UIO-66-NH (UN) and an MXene (TiC).
View Article and Find Full Text PDFTiCT/Au NPs/PPy ternary heterostructure-based intra-capacitive self-powered sensor for DEHP detection.
J Hazard Mater
January 2025
Department of Analytical Chemistry, College of Chemistry, Jilin University, Changchun 130012, China. Electronic address:
Phthalate esters, particularly di(2-ethylhexyl) phthalate (DEHP), are widely used plasticizers found in various consumer products, posing significant environmental and health risks due to their endocrine-disrupting effects. In this study, a novel enzyme-free intra-capacitive biofuel cell self-powered sensor (ICBFC-SPS) was developed. The ICBFC-SPS integrated a ternary heterostructure-based capacitive anode and a cathode with a sensing interface into a single-chamber electrolytic cell.
View Article and Find Full Text PDFPre-intercalated Sodium Ions Enhance Sodium Storage of MoS Anode by Mitigating Structural Dissociation.
Nano Lett
January 2025
School of Chemical Engineering and Technology, State Key Laboratory of Chemical Engineering, International Joint Laboratory of Low-carbon Chemical Engineering of Ministry of Education, Tianjin University, Tianjin 300072, P. R. China.
Molybdenum disulfide (MoS) is a promising anode for sodium-ion batteries (SIBs) due to its high theoretical capacity and layered structure. However, a poor reversible conversion reaction and a low initial Coulombic efficiency (ICE) limit its practical application. This study systematically investigated the potential of pre-intercalated sodium ions molybdenum disulfide (Na-MoS) as an anode material for SIBs.
View Article and Find Full Text PDFInversion of interlayer scale using dynamic data of production wells in bottom water reservoirs: Sangtamu Oilfield, Tarim basin.
Sci Rep
January 2025
Exploration and Development Research Institute, PetroChina Tarim Oilfield Company, Korla, 841000, China.
The target reservoir is a typical blocky bottom water reservoir. There are several interlayers of varying scales inside it, which impact the characteristics of the oil production and water breakthrough curves of the wells in the water flooding development oilfield, resulting in strong heterogeneity within the reservoir. The Sangtamu Oilfield has an average well spacing of approximately 600 m, causing a challenge in accurately identifying the range of small-scale interlayer spreading.
View Article and Find Full Text PDFInsights on Fabrication Strategies and Energy Storage Mechanisms of Transition Metal Dichalcogenides Cathodes for Aqueous Zn-Based Batteries.
Small
January 2025
Shenzhen Key Laboratory of Energy Materials for Carbon Neutrality, Shenzhen Institute of Advanced Technology, Chinese Academy of Sciences, Shenzhen, 518055, China.
Aqueous zinc-based batteries (AZBs) are gaining widespread attention owing to their intrinsic safety, relatively low electrode potential, and high theoretical capacity. Transition metal dichalcogenides (TMDs) have convenient 2D ion diffusion channels, so they have been identified as promising host materials for AZBs, but face several key challenges such as the narrow interlayer spacing and the lack of in-deep understanding energy storage mechanisms. This review presents a comprehensive summary and discussion of the intrinsic structure, charge storage mechanisms, and key fabrication strategies of TMD-based cathodes for AZBs.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!