Silicon nitride (Si_{3}N_{4}) has emerged as a promising material for integrated nonlinear photonics and has been used for broadband soliton microcombs and low-pulse-energy supercontinuum generation. Therefore, understanding all nonlinear optical properties of Si_{3}N_{4} is important. So far, only stimulated Brillouin scattering (SBS) has not yet been reported. Here we observe, for the first time, backward SBS in fully cladded Si_{3}N_{4} waveguides. The Brillouin gain spectrum exhibits an unusual multipeak structure resulting from hybridization with high-overtone bulk acoustic resonances of the silica cladding. The reported intrinsic Si_{3}N_{4} Brillouin gain at 25 GHz is estimated as 4×10^{-13} m/W. Moreover, the magnitude of the Si_{3}N_{4} photoelastic constant is estimated as |p_{12}|=0.047±0.004, which is nearly 6 times smaller than for silica. Since SBS imposes an optical power limitation for waveguides, our results explain the capability of Si_{3}N_{4} to handle high optical power, central for integrated nonlinear photonics.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1103/PhysRevLett.124.013902 | DOI Listing |
Micromachines (Basel)
December 2024
School of Physics, Changchun University of Science and Technology, Changchun 130012, China.
Tungsten oxide (WO) electrochromic devices are obtaining increasing interest due to their color change and thermal regulation. However, most previous work focuses on the absorption or transmission spectra of materials, rather than the optical parameters evolution in full spectrum in the electrochromic processes. Herein, we developed a systematic protocol of ex situ methods to clarify the evolutions of subtle structure changes, Raman vibration modes, and optical parameters of WO thin films in electrochromic processes as stimulated by dosage-dependent Li insertion.
View Article and Find Full Text PDFThe development of applications based on forward-stimulated Brillouin scattering (FSBS) in optical fibers has experienced a considerable increase in recent years, particularly in the area of fiber optic sensors. In this work, we present an experimental investigation to explore the limits of this physical mechanism in telecom optical fibers, whose results we think are of interest for the design of sensors in different areas. Specifically, we studied on the capability of the conventional probing method to detect FSBS in very short optical fibers, and the potential of FSBS to detect tiny diameter changes in the optical fiber.
View Article and Find Full Text PDFThe frequency stability of long-distance two-way fiber-optic radio frequency (RF) transfer is directly affected by the optical signal-to-noise ratio (OSNR) of optical amplifiers. In this paper, we have proposed a stimulated Brillouin scattering (SBS)-based optical amplification scheme with high OSNR for two-way fiber-optic RF frequency transfer over single mode fibers (SMF). At the remote and local site, the modulated carrier transferred from the opposite was amplified and then frequency upshifted by Brillouin frequency shift (BFS) for pump generation.
View Article and Find Full Text PDFBrillouin microscopy enables the assessment of the mechanical properties of biological tissues by mapping the Brillouin shift in three-dimensional (3D), all-optical, label-free, non-contact, and subcellular resolution. The virtually imaged phased array (VIPA) etalon is widely utilized for measuring Brillouin spectra owing to its superior light throughput, large angular dispersion, and rapid signal acquisition capabilities. The VIPA-based spectrometer plays a significant role in Brillouin microscopy, but it is highly sensitive to factors such as the tilt angle, beam radius, lens focal length, and so on.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!