Rapid development in wearable electronics and systems continues to impose challenges on portable energy storage sustained over time, and thus human energy harvesting is a potentially attractive means of sustainable, long-term energy. We introduce a novel 'controlled slip' energy harvesting approach for capturing energy during human locomotion. While slip is normally considered undesirable, controlled slip holds potential to enable a significant amount of energy harvesting during each step of human gait. Custom-designed 'controlled slip' energy harvesting shoes were fabricated by mounting a sliding plate and a generator with a one-way bearing to the sole of standard walking shoes, which induces controlled forward slip during early stance while energy is harvested. Fourteen healthy subjects performed treadmill walking trials with the 'controlled slip' energy harvesting shoes which generated average electrical power of 1.15-1.44 W at walking speeds of 2.9-4.3 km/h. Interestingly, without prompting, subjects chose to walk with the 'controlled slip' energy harvesting shoes in either one of two distinct ways: landing with the heel first (heel strikers) or landing with the toe first (toe strikers). While heel strikers and toe strikers exhibited similar electrical power output and hip flexion angle at initial foot contact, heel strikers had higher peak ankle power and lower knee flexion angle at initial foot contact than toe strikers. 'Controlled slip' energy harvesting could potentially generate electrical power for a broad spectrum of wearable devices.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1109/TNSRE.2019.2961428 | DOI Listing |
J Fluoresc
January 2025
Department of Physics \ Collage of Sciences, University of Kufa, Najaf, Iraq.
This research utilizes density functional theory to investigate the ground and excited-state properties of a new series of organic dyes with D-π-A configurations (D1-D6) for their potential application in dye-sensitized solar cells. The study focuses on modifying these dyes using various functional groups as π-bridges to optimize their electronic properties and improve their efficiency as sensitizers in DSSCs. The frontier molecular orbitals (HOMO and LUMO) were analysed to evaluate electron transfer properties.
View Article and Find Full Text PDFSensors (Basel)
January 2025
Laboratory of Sensors/Actuators and Energy Harvesting, National Institute for Research and Development in Electrical Engineering ICPE-CA, 030138 Bucharest, Romania.
The use of hydrogen as fuel presents many safety challenges due to its flammability and explosive nature, combined with its lack of color, taste, and odor. The purpose of this paper is to present an electrochemical sensor that can achieve rapid and accurate detection of hydrogen leakage. This paper presents both the component elements of the sensor, like sensing material, sensing element, and signal conditioning, as well as the electronic protection and signaling module of the critical concentrations of H.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
Portici Research Centre, ENEA-Italian National Agency for New Technologies, Energy and Sustainable Economic Development, 80055 Portici, Italy.
Polyvinylidene fluoride (PVDF)-based materials are the most researched polymers in the field of energy harvesting. Their production in thin-film form through printing technologies can potentially offer several manufacturing and performance advantages, such as low-cost, low-temperature processing, use of flexible substrates, custom design, low thermal inertia and surface-scaling performance. However, solution-based processes, like printing, miss fine control of the microstructure during film-forming, making it difficult to achieve a high level of polarization, necessary for PVDF to exhibit electroactive characteristics.
View Article and Find Full Text PDFAdv Sci (Weinh)
January 2025
Institute of Molecular Science, University of Valencia, c/Catedrático José Beltrán Martínez 2, Paterna, 46980, Valencia, Spain.
Energy transfer processes in nanohybrids are at the focal point of conceptualizing, designing, and realizing novel energy-harvesting systems featuring nanocrystals that absorb photons and transfer their energy unidirectionally to surface-immobilized functional dyes. Importantly, the functionality of these dyes defines the ultimate application. Herein, CsPbBr perovskite nanocrystals (NCs) are interfaced with zinc phthalocyanine (ZnPc) dyes featuring carboxylic acid.
View Article and Find Full Text PDFACS Nano
January 2025
Beijing Key Laboratory of Lignocellulosic Chemistry, Beijing Forestry University, Beijing 100083, China.
Conductive eutectogels have emerged as candidates for constructing functional flexible electronics as they are free from the constraints posed by inherent defects associated with solvents and feeble network structures. Nevertheless, developing a facile, environmentally friendly, and rapid polymerization strategy for the construction of conductive eutectogels with integrated multifunctionality is still immensely challenging. Herein, a conductive eutectogel is fabricated through a one-step dialdehyde xylan (DAX)/liquid metal (LM)-initiated polymerization of a deep eutectic solvent.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!